lkml.org 
[lkml]   [2010]   [May]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: 2.6.35-rc1 fails to boot: OOPS in ir_register_class
From
Date
On Mon, 2010-05-31 at 07:25 +0200, Torsten Kaiser wrote:
> Trying to boot the new -rc1 it fails with the following OOPS:
> [ 3.454804] IR NEC protocol handler initialized
> [ 3.461310] IR RC5(x) protocol handler initialized
> [ 3.467865] IR RC6 protocol handler initialized
> [ 3.474070] IR JVC protocol handler initialized
> [ 3.480257] IR Sony protocol handler initialized
> [ 3.480259] Linux video capture interface: v2.00
> [ 3.480722] bttv: driver version 0.9.18 loaded
> [ 3.480724] bttv: using 8 buffers with 2080k (520 pages) each for capture
> [ 3.507950] bttv: Bt8xx card found (0).
> [ 3.513845] ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 19
> [ 3.521339] bttv 0000:05:06.0: PCI INT A -> Link[LNKC] -> GSI 19
> (level, low) -> IRQ 19
> [ 3.531039] bttv0: Bt878 (rev 17) at 0000:05:06.0, irq: 19,
> latency: 64, mmio: 0xeefff000
> [ 3.541062] bttv0: detected: Hauppauge WinTV [card=10], PCI
> subsystem ID is 0070:13eb
> [ 3.550946] bttv0: using: Hauppauge (bt878) [card=10,autodetected]
> [ 3.561433] bttv0: Hauppauge/Voodoo msp34xx: reset line init [5]
> [ 3.593765] usb 2-6: new low speed USB device using ohci_hcd and address 2
> [ 3.599016] tveeprom 4-0050: Hauppauge model 61344, rev D421, serial# 3902813
> [ 3.599018] tveeprom 4-0050: tuner model is Philips FM1216 (idx 21, type 5)
> [ 3.599021] tveeprom 4-0050: TV standards PAL(B/G) (eeprom 0x04)
> [ 3.599022] tveeprom 4-0050: audio processor is MSP3415 (idx 6)
> [ 3.599024] tveeprom 4-0050: has radio
> [ 3.599025] bttv0: Hauppauge eeprom indicates model#61344
> [ 3.599027] bttv0: tuner type=5
> [ 3.609618] msp3400 4-0040: MSP3415D-B3 found @ 0x80 (bt878 #0 [sw])
> [ 3.609620] msp3400 4-0040: msp3400 supports nicam, mode is autodetect
> [ 3.621863] tuner 4-0061: chip found @ 0xc2 (bt878 #0 [sw])
> [ 3.622168] tuner-simple 4-0061: creating new instance
> [ 3.622170] tuner-simple 4-0061: type set to 5 (Philips PAL_BG
> (FI1216 and compatibles))
> [ 3.622882] bttv0: registered device video0
> [ 3.622940] bttv0: registered device vbi0
> [ 3.622997] bttv0: registered device radio0
> [ 3.632337] bttv0: PLL: 28636363 => 35468950 .. ok
> [ 3.683096] Registered IR keymap rc-rc5-tv
> [ 3.683110] BUG: unable to handle kernel NULL pointer dereference at (null)
> [ 3.683113] IP: [<ffffffff813ebe79>] ir_register_class+0x59/0x160
> [ 3.683122] PGD 0
> [ 3.683124] Oops: 0000 [#1] SMP
> [ 3.683125] last sysfs file:
> [ 3.683127] CPU 2
> [ 3.683129] Modules linked in:
> [ 3.683130]
> [ 3.683133] Pid: 1, comm: swapper Not tainted 2.6.35-rc1 #1 KFN5-D
> SLI/KFN5-D SLI
> [ 3.683135] RIP: 0010:[<ffffffff813ebe79>] [<ffffffff813ebe79>]
> ir_register_class+0x59/0x160
> [ 3.683139] RSP: 0018:ffff88011ff09cd0 EFLAGS: 00010246
> [ 3.683141] RAX: 0000000000000000 RBX: ffff88011f3c1a00 RCX: ffffffff81a5baa0
> [ 3.683142] RDX: 0000000000000000 RSI: ffffffff817d24f0 RDI: ffff88011f3c1a00
> [ 3.683144] RBP: 0000000000000000 R08: 0000000000000000 R09: 0000000000000000
> [ 3.683146] R10: 0000000000000000 R11: 0000000000000021 R12: ffffffff817d6960
> [ 3.683147] R13: ffff88011f223000 R14: ffff88011f3c1a00 R15: ffff88011f3c1b40
> [ 3.683150] FS: 00000000010f8870(0000) GS:ffff880080200000(0000)
> knlGS:0000000000000000
> [ 3.683151] CS: 0010 DS: 0000 ES: 0000 CR0: 000000008005003b
> [ 3.683153] CR2: 0000000000000000 CR3: 0000000001a05000 CR4: 00000000000006e0
> [ 3.683155] DR0: 0000000000000000 DR1: 0000000000000000 DR2: 0000000000000000
> [ 3.683157] DR3: 0000000000000000 DR6: 00000000ffff0ff0 DR7: 0000000000000400
> [ 3.683159] Process swapper (pid: 1, threadinfo ffff88011ff08000,
> task ffff88007ff48000)
> [ 3.683160] Stack:
> [ 3.683162] ffff88011f223000 ffffffff81a5ab30 ffff88011f223000
> ffffffff817d6960
> [ 3.683164] <0> 0000000000000021 ffffffff813eb90a ffff880100000028
> ffffffff817d240e
> [ 3.683166] <0> ffff88011f3c1b68 0000000000000282 ffff8800070b54e0
> ffff88011f35f100
> [ 3.683169] Call Trace:
> [ 3.683174] [<ffffffff813eb90a>] ? __ir_input_register+0x2ba/0x350
> [ 3.683178] [<ffffffff8141730a>] ? ir_probe+0x36a/0x4f0
> [ 3.683181] [<ffffffff81416fa0>] ? ir_probe+0x0/0x4f0
> [ 3.683185] [<ffffffff813d9bca>] ? i2c_device_probe+0xea/0x120
> [ 3.683188] [<ffffffff813367aa>] ? driver_sysfs_add+0x5a/0x80
> [ 3.683190] [<ffffffff813368d3>] ? driver_probe_device+0x83/0x190
> [ 3.683193] [<ffffffff813d9c54>] ? i2c_device_match+0x54/0x70
> [ 3.683195] [<ffffffff81336d03>] ? __driver_attach+0x93/0xa0
> [ 3.683197] [<ffffffff81336c70>] ? __driver_attach+0x0/0xa0
> [ 3.683201] [<ffffffff81335bf8>] ? bus_for_each_dev+0x58/0x80
> [ 3.683203] [<ffffffff81335ea0>] ? bus_add_driver+0xb0/0x250
> [ 3.683206] [<ffffffff81336e4a>] ? driver_register+0x6a/0x130
> [ 3.683209] [<ffffffff812124a0>] ? __pci_register_driver+0x80/0xc0
> [ 3.683212] [<ffffffff813daa30>] ? i2c_register_driver+0x30/0xb0
> [ 3.683217] [<ffffffff81ae990d>] ? bttv_init_module+0x0/0xde
> [ 3.683220] [<ffffffff81ae9b09>] ? ir_init+0x0/0x14
> [ 3.683224] [<ffffffff810001d4>] ? do_one_initcall+0x34/0x190
> [ 3.683227] [<ffffffff81ac36d6>] ? kernel_init+0x143/0x1cd
> [ 3.683230] [<ffffffff81003194>] ? kernel_thread_helper+0x4/0x10
> [ 3.683232] [<ffffffff81ac3593>] ? kernel_init+0x0/0x1cd
> [ 3.683235] [<ffffffff81003190>] ? kernel_thread_helper+0x0/0x10
> [ 3.683237] Code: c7 80 a5 ba 81 48 89 c3 e8 b5 8f e0 ff 85 c0 89
> c5 78 62 48 8b 93 78 01 00 00 48 c7 c1 a0 ba a5 81 48 c7 c6 f0 24 7d
> 81 48 89 df <8b> 12 48 c7 83 20 01 00 00 20 ba a5 81 85 d2 48 c7 c2 e0
> ba a5

Refer to the linux/drivers/media/IR/ir-sysfs.c:ir_register_class().

That Oops code disassembles to this:

33: 48 89 c3 mov %rax,%rbx
36: e8 b5 8f e0 ff callq 0xffffffffffe08ff0 <--- devno = find_first_zero_bit()
3b: 85 c0 test %eax,%eax <--- if (unlikely(devno < 0))
3d: 89 c5 mov %eax,%ebp
3f: 78 62 js 0xa3 <--- return devno
41: 48 8b 93 78 01 00 00 mov 0x178(%rbx),%rdx <--- %rdx = irdev->props
48: 48 c7 c1 a0 ba a5 81 mov $0xffffffff81a5baa0,%rcx
4f: 48 c7 c6 f0 24 7d 81 mov $0xffffffff817d24f0,%rsi
56: 48 89 df mov %rbx,%rdi
59: 8b 12 mov (%rdx),%edx <-------- Ooops here %edx = irdev->props->driver_type
5b: 48 c7 83 20 01 00 00 movq $0xffffffff81a5ba20,0x120(%rbx)

As best I can tell, in this oops irdev->props was NULL in
ir_register_class().

I don't know if ir_dev->props is always supposed to get set, but
__ir_input_register() appears to check for it being NULL and then allows
the call to ir_register_class() to happen. Of note is that if one fixes
ir_register_class() to handle a NULL props pointer, the next if()
statement in __ir_input_register() will then try to dereference the NULL
pointer and then Oops.


Regards,
Andy



\
 
 \ /
  Last update: 2010-05-31 21:43    [W:0.085 / U:0.148 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site