Messages in this thread | | | Subject | Re: bit errors on spitz | From | Stanislav Brabec <> | Date | Sun, 21 Mar 2010 22:42:33 +0100 |
| |
Pavel Machek píše v Ne 21. 03. 2010 v 21:43 +0100: > On Fri 2010-03-12 10:07:04, Stanislav Brabec wrote:
> > > > Good tip. It seems that nobody ported driver for the voltage control > > > > chip ISL6271 from 2.4 kernel, and bootloader probably does not set > > > > correct values. > > Are we sure about this one? If we have wrong voltages on various > parts, that kind-off explains it. > > Would it be possible to measure (Voltmeter) difference between 2.4 > kernel and 2.6 kernel?
If you are ready to run Zaurus in dismantled state, then yes. Measure on the upper pin of the large coil in the center of the http://www.penguin.cz/~utx/zaurus/pcbt_uc.jpg image or on the testpoint nearby (probably to the right).
Alternatively, it is possible to write a driver. It is just one byte write and one byte read via I2C.
________________________________________________________________________ Stanislav Brabec http://www.penguin.cz/~utx/zaurus
-- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |