lkml.org 
[lkml]   [2010]   [Feb]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH 3/4] firewire: get_cycle_timer optimization and cleanup
ohci:  Break out of the retry loop if too many attempts were necessary.
This may theoretically happen if the chip is fatally defective or if the
get_cycle_timer ioctl was performed after a CardBus controller was
ejected.

Also micro-optimize the loop by re-using the last two register reads in
the next iteration, remove a questionable inline keyword, and shuffle a
comment around.

core: ioctl_get_cycle_timer() is always called with interrupts on,
therefore local_irq_save() can be replaced by local_irq_disable().
Disabled local IRQs imply disabled preemption, hence preempt_disable()
can be removed.

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
---
drivers/firewire/core-cdev.c | 17 ++++------
drivers/firewire/ohci.c | 57 ++++++++++++++++++-----------------
2 files changed, 36 insertions(+), 38 deletions(-)

Index: linux-2.6.33-rc8/drivers/firewire/core-cdev.c
===================================================================
--- linux-2.6.33-rc8.orig/drivers/firewire/core-cdev.c
+++ linux-2.6.33-rc8/drivers/firewire/core-cdev.c
@@ -25,6 +25,7 @@
#include <linux/firewire.h>
#include <linux/firewire-cdev.h>
#include <linux/idr.h>
+#include <linux/irqflags.h>
#include <linux/jiffies.h>
#include <linux/kernel.h>
#include <linux/kref.h>
@@ -32,8 +33,6 @@
#include <linux/module.h>
#include <linux/mutex.h>
#include <linux/poll.h>
-#include <linux/preempt.h>
-#include <linux/sched.h>
#include <linux/spinlock.h>
#include <linux/string.h>
#include <linux/time.h>
@@ -1035,21 +1034,19 @@ static int ioctl_get_cycle_timer(struct
{
struct fw_cdev_get_cycle_timer *request = buffer;
struct fw_card *card = client->device->card;
- unsigned long long bus_time;
struct timeval tv;
- unsigned long flags;
+ u32 cycle_time;

- preempt_disable();
- local_irq_save(flags);
+ local_irq_disable();

- bus_time = card->driver->get_bus_time(card);
+ cycle_time = card->driver->get_bus_time(card);
do_gettimeofday(&tv);

- local_irq_restore(flags);
- preempt_enable();
+ local_irq_enable();

request->local_time = tv.tv_sec * 1000000ULL + tv.tv_usec;
- request->cycle_timer = bus_time & 0xffffffff;
+ request->cycle_timer = cycle_time;
+
return 0;
}

Index: linux-2.6.33-rc8/drivers/firewire/ohci.c
===================================================================
--- linux-2.6.33-rc8.orig/drivers/firewire/ohci.c
+++ linux-2.6.33-rc8/drivers/firewire/ohci.c
@@ -1795,60 +1795,61 @@ static int ohci_enable_phys_dma(struct f
#endif /* CONFIG_FIREWIRE_OHCI_REMOTE_DMA */
}

-static inline u32 cycle_timer_ticks(u32 cycle_timer)
+static u32 cycle_timer_ticks(u32 cycle_timer)
{
u32 ticks;

ticks = cycle_timer & 0xfff;
ticks += 3072 * ((cycle_timer >> 12) & 0x1fff);
ticks += (3072 * 8000) * (cycle_timer >> 25);
+
return ticks;
}

+/*
+ * Some controllers exhibit one or more of the following bugs when updating the
+ * iso cycle timer register:
+ * - When the lowest six bits are wrapping around to zero, a read that happens
+ * at the same time will return garbage in the lowest ten bits.
+ * - When the cycleOffset field wraps around to zero, the cycleCount field is
+ * not incremented for about 60 ns.
+ * - Occasionally, the entire register reads zero.
+ *
+ * To catch these, we read the register three times and ensure that the
+ * difference between each two consecutive reads is approximately the same, i.e.
+ * less than twice the other. Furthermore, any negative difference indicates an
+ * error. (A PCI read should take at least 20 ticks of the 24.576 MHz timer to
+ * execute, so we have enough precision to compute the ratio of the differences.)
+ */
static u64 ohci_get_bus_time(struct fw_card *card)
{
struct fw_ohci *ohci = fw_ohci(card);
u32 c0, c1, c2;
u32 t0, t1, t2;
s32 diff01, diff12;
- u64 bus_time;
+ int i;
+
+ c2 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);

- if (!ohci->iso_cycle_timer_quirk) {
+ if (ohci->iso_cycle_timer_quirk) {
+ i = 0;
+ c1 = c2;
c2 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);
- } else {
- /*
- * Some controllers exhibit one or more of the following bugs
- * when updating the iso cycle timer register:
- * - When the lowest six bits are wrapping around to zero,
- * a read that happens at the same time will return garbage
- * in the lowest ten bits.
- * - When the cycleOffset field wraps around to zero, the
- * cycleCount field is not incremented for about 60 ns.
- * - Occasionally, the entire register reads zero.
- *
- * To catch these, we read the register three times and ensure
- * that the difference between each two consecutive reads is
- * approximately the same, i.e., less than twice the other.
- * Furthermore, any negative difference indicates an error.
- * (A PCI read should take at least 20 ticks of the 24.576 MHz
- * timer to execute, so we have enough precision to compute the
- * ratio of the differences.)
- */
do {
- c0 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);
- c1 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);
+ c0 = c1;
+ c1 = c2;
c2 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);
t0 = cycle_timer_ticks(c0);
t1 = cycle_timer_ticks(c1);
t2 = cycle_timer_ticks(c2);
diff01 = t1 - t0;
diff12 = t2 - t1;
- } while (diff01 <= 0 || diff12 <= 0 ||
- diff01 / diff12 >= 2 || diff12 / diff01 >= 2);
+ } while ((diff01 <= 0 || diff12 <= 0 ||
+ diff01 / diff12 >= 2 || diff12 / diff01 >= 2)
+ && i++ < 20);
}
- bus_time = ((u64)atomic_read(&ohci->bus_seconds) << 32) | c2;

- return bus_time;
+ return ((u64)atomic_read(&ohci->bus_seconds) << 32) | c2;
}

static void copy_iso_headers(struct iso_context *ctx, void *p)
--
Stefan Richter
-=====-==-=- --=- -===-
http://arcgraph.de/sr/


\
 
 \ /
  Last update: 2010-02-14 18:51    [W:0.185 / U:0.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site