lkml.org 
[lkml]   [2010]   [Nov]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/4][v2] powerpc: add e500 HID1 bit definition
Date
From: Li Yang <leoli@freescale.com>

Also make 74xx HID1 definition conditional.

Signed-off-by: Li Yang <leoli@freescale.com>
Signed-off-by: Shaohui Xie <b21989@freescale.com>
Cc: Li Yang <leoli@freescale.com>
Cc: Kumar Gala <kumar.gala@freescale.com>
Cc: Roy Zang <tie-fei.zang@freescale.com>
Cc: Alexandre Bounine <alexandre.bounine@idt.com>
---
These patches have been send for almost one week, and has no feedback.

arch/powerpc/include/asm/reg.h | 2 ++
arch/powerpc/include/asm/reg_booke.h | 14 ++++++++++++++
2 files changed, 16 insertions(+), 0 deletions(-)

diff --git a/arch/powerpc/include/asm/reg.h b/arch/powerpc/include/asm/reg.h
index ff0005e..125fc1a 100644
--- a/arch/powerpc/include/asm/reg.h
+++ b/arch/powerpc/include/asm/reg.h
@@ -283,6 +283,7 @@
#define HID0_NOPTI (1<<0) /* No-op dcbt and dcbst instr. */

#define SPRN_HID1 0x3F1 /* Hardware Implementation Register 1 */
+#ifdef CONFIG_6xx
#define HID1_EMCP (1<<31) /* 7450 Machine Check Pin Enable */
#define HID1_DFS (1<<22) /* 7447A Dynamic Frequency Scaling */
#define HID1_PC0 (1<<16) /* 7450 PLL_CFG[0] */
@@ -292,6 +293,7 @@
#define HID1_SYNCBE (1<<11) /* 7450 ABE for sync, eieio */
#define HID1_ABE (1<<10) /* 7450 Address Broadcast Enable */
#define HID1_PS (1<<16) /* 750FX PLL selection */
+#endif
#define SPRN_HID2 0x3F8 /* Hardware Implementation Register 2 */
#define SPRN_HID2_GEKKO 0x398 /* Gekko HID2 Register */
#define SPRN_IABR 0x3F2 /* Instruction Address Breakpoint Register */
diff --git a/arch/powerpc/include/asm/reg_booke.h b/arch/powerpc/include/asm/reg_booke.h
index 667a498..dc6adff 100644
--- a/arch/powerpc/include/asm/reg_booke.h
+++ b/arch/powerpc/include/asm/reg_booke.h
@@ -246,6 +246,20 @@
store or cache line push */
#endif

+/* Bit definitions for the HID1 */
+#ifdef CONFIG_E500
+/* e500v1/v2 */
+#define HID1_PLL_CFG_MASK 0xfc000000 /* PLL_CFG input pins */
+#define HID1_RFXE 0x00020000 /* Read fault exception enable */
+#define HID1_R1DPE 0x00008000 /* R1 data bus parity enable */
+#define HID1_R2DPE 0x00004000 /* R2 data bus parity enable */
+#define HID1_ASTME 0x00002000 /* Address bus streaming mode enable */
+#define HID1_ABE 0x00001000 /* Address broadcast enable */
+#define HID1_MPXTT 0x00000400 /* MPX re-map transfer type */
+#define HID1_ATS 0x00000080 /* Atomic status */
+#define HID1_MID_MASK 0x0000000f /* MID input pins */
+#endif
+
/* Bit definitions for the DBSR. */
/*
* DBSR bits which have conflicting definitions on true Book E versus IBM 40x.
--
1.6.4



\
 
 \ /
  Last update: 2010-11-03 11:25    [W:0.046 / U:1.212 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site