lkml.org 
[lkml]   [2010]   [Jan]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    Date
    From
    Subject[PATCH 2/5] x86: using logical flat for amd cpu too.
    not sure it works again, could be bios fix the irq routing dest ?

    tested that amd support logical flat too when cpus num <= 8 and even
    bsp apic id > 8

    so could remove vendor check...

    Signed-off-by: Yinghai Lu <yinghai@kernel.org>

    ---
    arch/x86/kernel/apic/apic.c | 11 ++---------
    arch/x86/kernel/apic/probe_64.c | 13 ++-----------
    2 files changed, 4 insertions(+), 20 deletions(-)

    Index: linux-2.6/arch/x86/kernel/apic/apic.c
    ===================================================================
    --- linux-2.6.orig/arch/x86/kernel/apic/apic.c
    +++ linux-2.6/arch/x86/kernel/apic/apic.c
    @@ -1898,15 +1898,8 @@ void __cpuinit generic_processor_info(in
    max_physical_apicid = apicid;

    #ifdef CONFIG_X86_32
    - switch (boot_cpu_data.x86_vendor) {
    - case X86_VENDOR_INTEL:
    - if (num_processors > 8)
    - def_to_bigsmp = 1;
    - break;
    - case X86_VENDOR_AMD:
    - if (max_physical_apicid >= 8)
    - def_to_bigsmp = 1;
    - }
    + if (num_processors > 8)
    + def_to_bigsmp = 1;
    #endif

    #if defined(CONFIG_SMP) || defined(CONFIG_X86_64)
    Index: linux-2.6/arch/x86/kernel/apic/probe_64.c
    ===================================================================
    --- linux-2.6.orig/arch/x86/kernel/apic/probe_64.c
    +++ linux-2.6/arch/x86/kernel/apic/probe_64.c
    @@ -67,17 +67,8 @@ void __init default_setup_apic_routing(v
    }
    #endif

    - if (apic == &apic_flat) {
    - switch (boot_cpu_data.x86_vendor) {
    - case X86_VENDOR_INTEL:
    - if (num_processors > 8)
    - apic = &apic_physflat;
    - break;
    - case X86_VENDOR_AMD:
    - if (max_physical_apicid >= 8)
    - apic = &apic_physflat;
    - }
    - }
    + if (apic == &apic_flat && num_processors > 8)
    + apic = &apic_physflat;

    printk(KERN_INFO "Setting APIC routing to %s\n", apic->name);


    \
     
     \ /
      Last update: 2010-01-13 00:21    [W:0.022 / U:36.740 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site