lkml.org 
[lkml]   [2009]   [Jul]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH] au1xmmc: dev_pm_ops conversion
From
Good Morning Frans,

On Mon, Jul 20, 2009 at 10:00 PM, Frans Pop<elendil@planet.nl> wrote:
>> Signed-off-by: Manuel Lauss <manuel.lauss@gmail.com>
>> ---
>> Run-tested on Au1200.
>>
>>  drivers/mmc/host/au1xmmc.c |   23 +++++++++++------------
>>  1 files changed, 11 insertions(+), 12 deletions(-)
>>
>> diff --git a/drivers/mmc/host/au1xmmc.c b/drivers/mmc/host/au1xmmc.c
>> index d3f5561..70509c9 100644
>> --- a/drivers/mmc/host/au1xmmc.c
>> +++ b/drivers/mmc/host/au1xmmc.c
>> @@ -1131,13 +1131,12 @@ static int __devexit au1xmmc_remove(struct
>> platform_device *pdev) return 0;
>>  }
>>
>> -#ifdef CONFIG_PM
>
> Won't the removal of this test cause a build failure if CONFIG_PM is not
> set? If the removal of the test is safe, this should IMHO at least be
> explained in the commit message.

No, it builds just fine without CONFIG_PM; it was there to shave off a
few bytes from the kernel image. But not everyone tests this driver
with CONFIG_PM=y, because apparently noone really needed PM on
this platform (Alchemy), and a full build of most of the boards using this
driver fails with PM enabled.

This way the PM methods at least get a compile-test in the non-pm case.


>> -static int au1xmmc_suspend(struct platform_device *pdev, pm_message_t
>> state) +static int au1xmmc_suspend(struct device *dev)
>>  {
>> -       struct au1xmmc_host *host = platform_get_drvdata(pdev);
>> +       struct au1xmmc_host *host = dev_get_drvdata(dev);
>>         int ret;
>>
>> -       ret = mmc_suspend_host(host->mmc, state);
>> +       ret = mmc_suspend_host(host->mmc, PMSG_SUSPEND);
>>         if (ret)
>>                 return ret;
>>
>> @@ -1150,27 +1149,27 @@ static int au1xmmc_suspend(struct
>> platform_device *pdev, pm_message_t state) return 0;
>>  }
>>
>> -static int au1xmmc_resume(struct platform_device *pdev)
>> +static int au1xmmc_resume(struct device *dev)
>>  {
>> -       struct au1xmmc_host *host = platform_get_drvdata(pdev);
>> +       struct au1xmmc_host *host = dev_get_drvdata(dev);
>>
>>         au1xmmc_reset_controller(host);
>>
>>         return mmc_resume_host(host->mmc);
>>  }
>> -#else
>> -#define au1xmmc_suspend NULL
>> -#define au1xmmc_resume NULL
>
> ... drop the 3 lines above (as you did) ...
>
>> -#endif
>
> ... move this #endif to after the new struct below ...
>
>> +
>> +static struct dev_pm_ops au1xmmc_pmops = {
>> +       .resume         = au1xmmc_resume,
>> +       .suspend        = au1xmmc_suspend,
>> +};
>>
>>  static struct platform_driver au1xmmc_driver = {
>>         .probe         = au1xmmc_probe,
>>         .remove        = au1xmmc_remove,
>> -       .suspend       = au1xmmc_suspend,
>> -       .resume        = au1xmmc_resume,
>>         .driver        = {
>>                 .name  = DRIVER_NAME,
>>                 .owner = THIS_MODULE,
>> +               .pm    = &au1xmmc_pmops,

I like what Magnus Damm did for some of the SuperH drivers:

#ifdef CONFIG_PM
[...]
#define DRIVER_PM_OPS (&driver_pm_ops)
#else
#define DRIVER_PM_OPS NULL
#endif

...
.driver = {
...
.pm = DRIVER_PM_OPS,
}
...

I'd like to keep the pm stuff enabled at all times since it doesn't hurt
in the non-pm case and if kernel size becomes a problem I can add the
#defines back.

What do you think?

Thank you!
Manuel Lauss
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2009-07-21 07:15    [W:0.032 / U:1.216 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site