lkml.org 
[lkml]   [2009]   [May]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: sata_sil24 EH complete
Tim Connors wrote:
> With 2.6.29, when I hotplug a western digital mybook into a 'Silicon
> Image, Inc. SiI 3132 Serial ATA Raid II Controller', the drive is not
> found:
>
>
> *** drive failed due to user induced sillyness
> ...
> [18676.308750] sd 0:0:0:0: [sdb] Stopping disk
> [18676.308770] sd 0:0:0:0: [sdb] START_STOP FAILED
> [18676.308774] sd 0:0:0:0: [sdb] Result: hostbyte=DID_BAD_TARGET driverbyte=DRIVER_OK,SUGGEST_OK
> *** drive plugged back in
> [18767.821747] ata1: exception Emask 0x10 SAct 0x0 SErr 0x0 action 0xe frozen
> [18767.821756] ata1: irq_stat 0x00b40090, PHY RDY changed
> [18767.821775] ata1: hard resetting link
> [18774.633185] ata1: SATA link up 3.0 Gbps (SStatus 123 SControl 0)
> [18774.773591] ata1.00: applying link speed limit horkage to 1.5 Gbps
> [18779.655674] ata1: hard resetting link
> [18781.861074] ata1: SATA link up 1.5 Gbps (SStatus 113 SControl 10)
> [18782.178565] ata1.00: configured for UDMA/100
> [18782.178579] ata1: EH complete
>
> And then nothing. The device is still alive - if I plug it back in
> through its usb interface, it comes up normally. I know from experience
> that if I was to reboot the machine, it would have come up quite nicely
> from boot:

Hmm... "ata1.00: configured for UDMA/100" means libata part of
configuration went okay but it looks like SCSI probing didn't kick in
for reason. Is this always reproducible?

Thanks.

--
tejun


\
 
 \ /
  Last update: 2009-05-06 02:35    [W:0.103 / U:0.068 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site