lkml.org 
[lkml]   [2009]   [May]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
SubjectRe: [PATCH 2/3]: x86-64: Handle SRAT v1 and v2 consistently
From
On Mon, May 18, 2009 at 2:47 AM, Kurt Garloff <garloff@suse.de> wrote:
> Hi,
>
> x86-64 was rather inconsistent prior to this patch; it used 8 bits
> for the pxm field in cpu_affinity, but 32 bits in mem_affinity.
> This patch makes it consistent: Either use 8 bits consistently (SRAT
> rev 1 or lower) or 32 bits (SRAT rev 2 or higher).
>
> This is patch 2/3.
> --
> Kurt Garloff, VP OPS Partner Engineering -- Novell Inc.
>
From: Kurt Garloff <garloff@suse.de>
Subject: Use SRAT table rev to use 8bit or 32bit PXM fields (x86-64)
References: bnc#503038

In SRAT v1, we had 8bit proximity domain (PXM) fields; SRAT v2 provides
32bits for these. The new fields were reserved before.
According to the ACPI spec, the OS must disregrard reserved fields.

x86-64 was rather inconsistent prior to this patch; it used 8 bits
for the pxm field in cpu_affinity, but 32 bits in mem_affinity.
This patch makes it consistent: Either use 8 bits consistently (SRAT
rev 1 or lower) or 32 bits (SRAT rev 2 or higher).

This is patch 2/3.

Signed-off-by: Kurt Garloff <garloff@suse.de>

---
arch/x86/mm/srat_64.c | 4 ++++
1 file changed, 4 insertions(+)

Index: linux-2.6/arch/x86/mm/srat_64.c
===================================================================
--- linux-2.6.orig/arch/x86/mm/srat_64.c
+++ linux-2.6/arch/x86/mm/srat_64.c
@@ -154,6 +154,8 @@ acpi_numa_processor_affinity_init(struct
if ((pa->flags & ACPI_SRAT_CPU_ENABLED) == 0)
return;
pxm = pa->proximity_domain_lo;
+ if (acpi_srat_revision >= 2)
+ pxm |= *((unsigned int*)pa->proximity_domain_hi) << 8;
node = setup_node(pxm);
if (node < 0) {
printk(KERN_ERR "SRAT: Too many proximity domains %x\n", pxm);
@@ -255,6 +257,8 @@ acpi_numa_memory_affinity_init(struct ac
start = ma->base_address;
end = start + ma->length;
pxm = ma->proximity_domain;
+ if (acpi_srat_revision <= 1)
+ pxm &= 0xff;
node = setup_node(pxm);
if (node < 0) {
printk(KERN_ERR "SRAT: Too many proximity domains.\n");

Acked-by: Yinghai Lu <yinghai@kernel.org>


\
 
 \ /
  Last update: 2009-05-18 22:07    [W:0.096 / U:0.408 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site