Messages in this thread Patch in this message | | | Date | Mon, 18 May 2009 10:23:28 -0700 | From | Yinghai Lu <> | Subject | Re: tip: patches in git for irq and numa |
| |
please check following patch
Thanks
YH
Subject: [PATCH] x86: don't mark pin_programmed early
Peter bisected that | commit b9c61b70075c87a8612624736faf4a2de5b1ed30 | Date: Wed May 6 10:10:06 2009 -0700 | | x86/pci: update pirq_enable_irq() to setup io apic routing | | So we can set io apic routing only when enabling the device irq. wrecked his opteron box, ata1 interrupts fail to get through
and that ata1 is using irq 11 [ 1.451839] sata_svw 0000:01:0e.0: version 2.3 [ 1.456333] sata_svw 0000:01:0e.0: PCI INT A -> GSI 11 (level, low) -> IRQ 11 [ 1.463639] scsi0 : sata_svw [ 1.466949] scsi1 : sata_svw [ 1.470022] scsi2 : sata_svw [ 1.473090] scsi3 : sata_svw [ 1.476112] ata1: SATA max UDMA/133 mmio m8192@0xff3fe000 port 0xff3fe000 irq 11 [ 1.483490] ata2: SATA max UDMA/133 mmio m8192@0xff3fe000 port 0xff3fe100 irq 11 [ 1.490870] ata3: SATA max UDMA/133 mmio m8192@0xff3fe000 port 0xff3fe200 irq 11 [ 1.498247] ata4: SATA max UDMA/133 mmio m8192@0xff3fe000 port 0xff3fe300 irq 11
that pin is overlapped with pin with legacy ones. We should not set bits in pin_programmed here, so that those bit could be set later via io_apic_set_pci_routing()
Reported-by: Peter Zijlstra <peterz@infradead.org> Signed-off-by: Yinghai Lu <yinghai.lu@kernel.org>
diff --git a/arch/x86/kernel/apic/io_apic.c b/arch/x86/kernel/apic/io_apic.c index 6b7913b..ed6a91c 100644 --- a/arch/x86/kernel/apic/io_apic.c +++ b/arch/x86/kernel/apic/io_apic.c @@ -1538,7 +1538,10 @@ static void __init setup_IO_APIC_irqs(void) } cfg = desc->chip_data; add_pin_to_irq_node(cfg, node, apic_id, pin); - set_bit(pin, mp_ioapic_routing[apic_id].pin_programmed); + /* + * don't mark it in pin_programmed, so later acpi could + * set it correctly when irq < 16 + */ setup_IO_APIC_irq(apic_id, pin, irq, desc, irq_trigger(idx), irq_polarity(idx)); }
| |