lkml.org 
[lkml]   [2009]   [Dec]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: still getting allocation failures (was Re: [PATCH] vmscan: Stop kswapd waiting on congestion when the min watermark is not being met V2)
On Sun, Nov 29, 2009 at 08:42:09AM +0100, Tobi Oetiker wrote:
> Hi Mel,
>
> Thursday Tobias Oetiker wrote:
> > Hi Mel,
> >
> > Nov 13 Mel Gorman wrote:
> >
> > > The last version has a stupid bug in it. Sorry.
> > >
> > > Changelog since V1
> > > o Fix incorrect negation
> > > o Rename kswapd_no_congestion_wait to kswapd_skip_congestion_wait as
> > > suggested by Rik
> > >
> > > If reclaim fails to make sufficient progress, the priority is raised.
> > > Once the priority is higher, kswapd starts waiting on congestion. However,
> > > if the zone is below the min watermark then kswapd needs to continue working
> > > without delay as there is a danger of an increased rate of GFP_ATOMIC
> > > allocation failure.
> > >
> > > This patch changes the conditions under which kswapd waits on
> > > congestion by only going to sleep if the min watermarks are being met.
> >
> > I finally got around to test this together with the whole series on
> > 2.6.31.6. after running it for a day I have not yet seen a single
> > order:5 allocation problem ... (while I had several an hour before)
>
> > for the record, my kernel is now running with the following
> > patches:
> >
> > patch1:Date: Thu, 12 Nov 2009 19:30:31 +0000
> > patch1:Subject: [PATCH 1/5] page allocator: Always wake kswapd when restarting an allocation attempt after direct reclaim failed
> >
> > patch2:Date: Thu, 12 Nov 2009 19:30:32 +0000
> > patch2:Subject: [PATCH 2/5] page allocator: Do not allow interrupts to use ALLOC_HARDER
> >
> > patch3:Date: Thu, 12 Nov 2009 19:30:33 +0000
> > patch3:Subject: [PATCH 3/5] page allocator: Wait on both sync and async congestion after direct reclaim
> >
> > patch4:Date: Thu, 12 Nov 2009 19:30:34 +0000
> > patch4:Subject: [PATCH 4/5] vmscan: Have kswapd sleep for a short interval and double check it should be asleep
> >
> > patch5:Date: Fri, 13 Nov 2009 20:03:57 +0000
> > patch5:Subject: [PATCH] vmscan: Stop kswapd waiting on congestion when the min watermark is not being met V2
> >
> > patch6:Date: Tue, 17 Nov 2009 10:34:21 +0000
> > patch6:Subject: [PATCH] vmscan: Have kswapd sleep for a short interval and double check it should be asleep fix 1
> >
> I have now been running the new kernel for a few days and I am
> sorry to report that about a day after booting the allocation
> failures started showing again. More order:4 instead of order:5 ...
>

Why has the order changed?

Also, what allocator were you using in 2.6.30 and 2.6.31.6, SLAB or
SLUB? Did you happen to change them when upgrading the kernel?

--
Mel Gorman
Part-time Phd Student Linux Technology Center
University of Limerick IBM Dublin Software Lab


\
 
 \ /
  Last update: 2009-12-02 12:35    [W:0.159 / U:0.728 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site