[lkml]   [2009]   [Jan]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: 2.6.29-rc1 does not resume on Lenove T61
2009/1/11 Zdenek Kabelac <>:
> Hi
> I've booted and tested 2.6.29-rc1 (c59765042f53a79a7a65585042ff463b69cb248c)
> I've observed that suspend is unusable - it goes to sleep - the sleep
> LED is on. After few secs system turns on back itself - and stays in
> some frozen state

A have similar situation, one difference: I get blank screen during
resume from suspend to ram. Also sometimes, like You, system turns on
back itself.


> but most probably this is not very helpful - however it's kind of hard
> to bisect kernel, because patches in the transition from
> 2.6.28->2.6.29-rc1 usually caused a lot of unstable behavior on my
> T61.

The same. Suspend to disk die on this message:
(this is during go to suspend to disk, NOT resume)

I try bisect, but I got many other problems, like this:

So, I cannot finish bisect.


Config, dmesg:

Maciej Rutecki

 \ /
  Last update: 2009-01-11 21:19    [W:0.078 / U:36.948 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site