lkml.org 
[lkml]   [2008]   [Aug]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/3] gpiolib: make gpio_to_chip() public
On Mon, Aug 18, 2008 at 03:58:46PM +0200, Laurent Pinchart wrote:
[...]
> > Not exactly. But you can do this way, if you need to preserve
> > a direction. What I did is a bit different though.
> >
> > qe_gpio_set_dedicated() actually just restores a mode that
> > firmware had set up, including direction (since direction could
> > be a part of dedicated configuration).
> >
> > That is, upon GPIO controller registration, we save all registers,
> > then driver can set up a pin to a GPIO mode via standard API, and
> > then it can _revert_ a pin to a dedicated function via
> > qe_gpio_set_dedicated() call. Dedicated function is specified by
> > the firmware (or board file), we're just restoring it.
>
> The semantic of the set_dedicated() operation needs to be clearly
> defined then.

It is. We set up a dedicated function that firmware (or board file)
has configured.

> I can live with this behaviour, but it might not be
> acceptable for everybody.

For example?

> Your patch requires the firmware to set a pin in dedicated mode at
> bootup in order to be used later in dedicated mode.

Yes. On a PowerPC this is always true: firmware should set up PIO
config. Linux' board file could fixup the firmware though.

Another option would be to add some argument to the set_dedicated
call, thus the software could specify arbitrary dedicated
function (thus no need to save/restore anything). But this would
be SOC-model specific, thus no driver can use this argument anyway.

> If, for some
> reason (driver not loaded, ...), no GPIO user shows up for that
> pin, it will stay configured in dedicated mode.

Yes.

> It might be better to set the PAR bit unconditionally in

Why it might be better? That way you may set up wrong _GPIO_
mode, because you didn't set PAR bit (when PAR bit set
DIR/ODR/DAT bits are losing their meanings).

> qe_gpio_set_dedicated() instead of restoring its value. That way
> the board initialization code could just set the DIR, DAT and ODR
> bits for dedicated mode but still configure the pin in GPIO mode.

--
Anton Vorontsov
email: cbouatmailru@gmail.com
irc://irc.freenode.net/bd2


\
 
 \ /
  Last update: 2008-08-18 16:37    [W:0.078 / U:1.088 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site