lkml.org 
[lkml]   [2008]   [Jul]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [patch 2/3] kdump: add is_vmcore_usable() and vmcore_unusable()
On Tue, Jul 29, 2008 at 11:15:33AM -0400, Vivek Goyal wrote:
> On Tue, Jul 29, 2008 at 06:12:37PM +1000, Simon Horman wrote:
> > The usage of elfcorehdr_addr has changed recently
> > such that being set to ELFCORE_ADDR_MAX is used by
> > is_kdump_kernel() to indicate if the code is executing
> > in a kernel executed as a crash kernel.
> >
> > However, arch/ia64/kernel/setup.c:reserve_elfcorehdr will
> > rest elfcorehdr_addr to ELFCORE_ADDR_MAX on error,
> > which means any subsequent calls to is_kdump_kernel()
> > will return 0, even though they should return 1.
> >
> > Ok, at this point in time there are no subsequent calls,
> > but I think its fair to say that there is ample scope for error
> > or at the very least confusion.
> >
> > This patch add an extra state, ELFCORE_ADDR_ERR, which
> > indicates that elfcorehdr_addr was passed on the command line,
> > and thus execution is taking place in a crashdump kernel,
> > but vmcore can't be used for some reason. This is tested
> > for using is_vmcore_usable() and set using vmcore_unusable().
> > A subsequent patch makes use of this new code.
> >
> > To summarise, the states that elfcorehdr_addr can now be in are as follows:
> >
> > ELFCORE_ADDR_MAX: not a crashdump kernel
> > ELFCORE_ADDR_ERR: crashdump kernel but vmcore is unusable
> > any other value: crash dump kernel and vmcore is usable
> >
> > Signed-off-by: Simon Horman <horms@verge.net.au>
> >
> >
> > Index: linux-2.6/include/linux/crash_dump.h
> > ===================================================================
> > --- linux-2.6.orig/include/linux/crash_dump.h 2008-07-29 17:27:43.000000000 +1000
> > +++ linux-2.6/include/linux/crash_dump.h 2008-07-29 17:53:13.000000000 +1000
> > @@ -8,6 +8,7 @@
> > #include <linux/proc_fs.h>
> >
> > #define ELFCORE_ADDR_MAX (-1ULL)
> > +#define ELFCORE_ADDR_ERR (-2ULL)
> >
> > #ifdef CONFIG_PROC_VMCORE
> > extern unsigned long long elfcorehdr_addr;
> > @@ -36,5 +37,30 @@ static inline int is_kdump_kernel(void)
> > static inline int is_kdump_kernel(void) { return 0; }
> > #endif /* CONFIG_CRASH_DUMP */
> >
> > +#ifdef CONFIG_PROC_VMCORE
> > +/* is_vmcore_usable() checks if the kernel is booting after a panic and
> > + * the vmcore region is usable.
> > + *
> > + * This makes use of the fact that due to alignment 1 is not
> > + * a valid pointer, much in the vain of IS_ERR(), except
> > + * dealing directly with an unsigned long long rather than a pointer.
> > + */
> > +
> > +static inline int is_vmcore_usable(void)
> > +{
> > + return is_kdump_kernel() && elfcorehdr_addr != ELFCORE_ADDR_ERR ? 1 : 0;
> > +}
> > +
> > +/* vmcore_unusable() marks the vmcore as unusable, without disturbing
> > + * the logic of is_kdump_kernel()
> > + */
> > +
> > +static inline void vmcore_unusable(void)
> > +{
> > + if (!is_kdump_kernel())
> > + elfcorehdr_addr = ELFCORE_ADDR_ERR;
> > +}
>
> Hi Simon,
>
> Should above condition be "if(is_kdump_kernel())" instead of
> "if(!is_kdump_kernel())?
>
> I would think that you would like to mark a vmcore unusable only if, to
> begin with you were booting after a panic.
>
> If we being marking vmcore_unusable in case of normal kernel
> (!is_kdump_kernel()), then is_kdump_kernel() will start reporting
> normal kernel as kdump kernel?

Yes, you are correct. Sorry for the silly mistake. I'll repost with

if (!is_kdump_kernel())
...

--
Horms



\
 
 \ /
  Last update: 2008-07-30 00:41    [W:0.035 / U:0.136 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site