Messages in this thread Patch in this message | | | From | Bartlomiej Zolnierkiewicz <> | Date | Wed, 28 May 2008 23:40:54 +0200 | Subject | [PATCH 08/21] ali14xx: convert to use ide_timing_find_mode() |
| |
There should be no functional changes caused by this patch.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com> --- drivers/ide/Kconfig | 1 + drivers/ide/legacy/ali14xx.c | 3 ++- 2 files changed, 3 insertions(+), 1 deletion(-)
Index: b/drivers/ide/Kconfig =================================================================== --- a/drivers/ide/Kconfig +++ b/drivers/ide/Kconfig @@ -988,6 +988,7 @@ config BLK_DEV_4DRIVES config BLK_DEV_ALI14XX tristate "ALI M14xx support" + select IDE_TIMINGS help This driver is enabled at runtime using the "ali14xx.probe" kernel boot parameter. It enables support for the secondary IDE interface Index: b/drivers/ide/legacy/ali14xx.c =================================================================== --- a/drivers/ide/legacy/ali14xx.c +++ b/drivers/ide/legacy/ali14xx.c @@ -117,10 +117,11 @@ static void ali14xx_set_pio_mode(ide_dri u8 param1, param2, param3, param4; unsigned long flags; int bus_speed = ide_vlb_clk ? ide_vlb_clk : 50; + struct ide_timing *t = ide_timing_find_mode(XFER_PIO_0 + pio); /* calculate timing, according to PIO mode */ time1 = ide_pio_cycle_time(drive, pio); - time2 = ide_pio_timings[pio].active_time; + time2 = t->active; param3 = param1 = (time2 * bus_speed + 999) / 1000; param4 = param2 = (time1 * bus_speed + 999) / 1000 - param1; if (pio < 3) {
| |