lkml.org 
[lkml]   [2008]   [Mar]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] ide: Documentation/ide/ide.txt fixes
Date
* "hdx=cyls,heads,sects,wpcom,irq" should be "hdx=cyls,heads,sects".

* "hdx=" is for "x" from 'a' to 'u', "idex=" is for "x" from '0' to '9'.

* "idex=noautotune" is long gone.

* Obsoleted "ide0=" parameters were already removed from the documentation.

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
---
goes after "ide: mark special "ide0=" kernel parameters as obsoleted" patch

Documentation/ide/ide.txt | 12 +++---------
1 file changed, 3 insertions(+), 9 deletions(-)

Index: b/Documentation/ide/ide.txt
===================================================================
--- a/Documentation/ide/ide.txt
+++ b/Documentation/ide/ide.txt
@@ -105,7 +105,7 @@ Drives are normally found by auto-probin
For really weird situations, the apparent (fdisk) geometry can also be specified
on the kernel "command line" using LILO. The format of such lines is:

- hdx=cyls,heads,sects,wpcom,irq
+ hdx=cyls,heads,sects
or hdx=cdrom

where hdx can be any of hda through hdh, Three values are required
@@ -214,9 +214,9 @@ driver using the "options=" keyword to i
Summary of ide driver parameters for kernel command line
--------------------------------------------------------

- "hdx=" is recognized for all "x" from "a" to "h", such as "hdc".
+ "hdx=" is recognized for all "x" from "a" to "u", such as "hdc".

- "idex=" is recognized for all "x" from "0" to "3", such as "ide1".
+ "idex=" is recognized for all "x" from "0" to "9", such as "ide1".

"hdx=noprobe" : drive may be present, but do not probe for it

@@ -233,8 +233,6 @@ Summary of ide driver parameters for ker
"hdx=remap63" : remap the drive: add 63 to all sector numbers
(for DM OnTrack)

- "idex=noautotune" : driver will NOT attempt to tune interface speed
-
"hdx=autotune" : driver will attempt to tune interface speed
to the fastest PIO mode supported,
if possible for this drive only.
@@ -282,10 +280,6 @@ Summary of ide driver parameters for ker

"ide=reverse" : formerly called to pci sub-system, but now local.

-The following are valid ONLY on ide0, which usually corresponds
-to the first ATA interface found on the particular host, and the defaults for
-the base,ctl ports must not be altered.
-
"ide=doubler" : probe/support IDE doublers on Amiga

There may be more options than shown -- use the source, Luke!

\
 
 \ /
  Last update: 2008-03-22 16:19    [W:0.050 / U:0.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site