lkml.org 
[lkml]   [2008]   [Feb]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    Subject[BUG] 2.6.25-rc3 hangs in early boot on Sun Ultra5
    Booting 2.6.25-rc3 on my Ultra5 causes a hang before or as
    the console is switched over to the framebuffer. The console
    output is (extrapolated from dmesg in -rc2 and handwritten
    notes, as I don't have a serial cable to my U5):

    PROMLIB: Sun IEEE Boot Prom 'OBP 3.25.3 2000/06/29 14:12'
    PROMLIB: Root node compatible:
    *** the following line can't be seen in dmesg after rc2 has booted
    console [earlyprom0] enabled
    Linux version 2.6.25-rc3 (mikpe@sparge) (gcc version 4.2.3) #1 Mon Feb 25 18:49:41 CET 2008
    ARCH: SUN4U
    Ethernet address: 08:00:20:fd:ec:1f
    [0000000200000000-fffff80000400000] page_structs=262144 node=0 entry=0/0
    [0000000200000000-fffff80000800000] page_structs=262144 node=0 entry=1/0
    [0000000200000000-fffff80000c00000] page_structs=262144 node=0 entry=2/0
    [0000000200000000-fffff80001000000] page_structs=262144 node=0 entry=3/0
    OF stdout device is: /pci@1f,0/pci@1,1/SUNW,m64B@2
    PROM: Built device tree with 46617 bytes of memory.
    On node 0 totalpages: 32299
    Normal zone: 335 pages used for memmap
    Normal zone: 0 pages reserved
    Normal zone: 31964 pages, LIFO batch:7
    Movable zone: 0 pages used for memmap
    Built 1 zonelists in Zone order, mobility grouping on. Total pages: 31964
    Kernel command line: ro root=/dev/sda5
    PID hash table entries: 1024 (order: 10, 8192 bytes)
    clocksource: mult[28000] shift[16]
    clockevent: mult[66666666] shift[32]
    Console: colour dummy device 80x25
    *** the following line can't be seen in dmesg after rc2 has booted
    console handover: boot [earlyprom0] -> real [tty0]

    At this point rc3 hangs hard and won't even respond to sysrq.

    Another difference is that with rc2 the first few lines of kernel
    output while the console is still in OF mode either aren't shown
    or disappear quickly since the switch to the framebuffer occurs
    within a fraction of a second after the kernel has been loaded.
    With rc3 the kernel output (the text shown above) in the OF-mode
    console is very very slow.

    (I should have quoted my .config here but I forgot to bring it.
    It's exactly the same in rc2 and rc3, however.)

    I'll try some rc2->rc3 bisecting later.

    /Mikael


    \
     
     \ /
      Last update: 2008-02-25 21:43    [W:0.023 / U:0.332 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site