lkml.org 
[lkml]   [2008]   [Feb]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] Document huge memory/cache overhead of memory controller in Kconfig
Andi Kleen wrote:
> On Fri, Feb 22, 2008 at 05:44:47PM +0530, Balbir Singh wrote:
>> My concern with all the points you mentioned is that this solution might need to
>> change again,
>
> No why would it need to change again?
>
>> depending on the factors you've mentioned. vmalloc() is good and
>> straightforward, but it has these dependencies which could call for another
>> rewrite of the code.
>
> The hotplug change would not need a rewrite of anything, just
> some additional code in the SRAT parser to increase __VMALLOC_RESERVE for
> each hotplug region. It's likely <= 3 additional lines.
>

Yes, but that is hotplug changes only for i386/x86-64.

>>>>>> if we decided to use vmalloc space, we would need 64
>>>>>> MB of vmalloc'ed memory
>>>>> Yes and if you increase mem_map you need exactly the same space
>>>>> in lowmem too. So increasing the vmalloc reservation for this is
>>>>> equivalent. Just make sure you use highmem backed vmalloc.
>>>>>
>>>> I see two problems with using vmalloc. One, the reservation needs to be done
>>>> across architectures.
>>> Only on 32bit. Ok hacking it into all 32bit architectures might be
>>> difficult, but I assume it would be ok to rely on the architecture
>>> maintainers for that and only enable it on some selected architectures
>>> using Kconfig for now.
>>>
>> Yes, but that's not such a good idea
>
> Waiting for the maintainers? Why not?

It limits the platforms the code can run on. A feature independent of the
architecture should if possible not depend on architecture specific support

>
> I assume the memory controller would be primarily used on larger
> systems anyways and except for i386 these should be mostly 64bit
> these days anyways.
>
>>> On 64bit vmalloc should be by default large enough so it could
>>> be enabled for all 64bit architectures.
>>>
>>>> Two, a big vmalloc chunk is not node aware,
>>> vmalloc_node()
>>>
>> vmalloc_node() would need to work much the same way as mem_map does. I am
>
> would? It already is implemented and works just fine AFAIK.
>
> I don't understand the rest of your point.
>

Oh! I guess, it's the extra I am. The point I was trying to make was that we
would need to split up the cgroup map the same way as the per node mem_map.

> -Andi


--
Warm Regards,
Balbir Singh
Linux Technology Center
IBM, ISTL


\
 
 \ /
  Last update: 2008-02-22 16:55    [W:0.924 / U:0.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site