Messages in this thread | | | From | Ondrej Zary <> | Subject | pata_it821x in 2.6.27 - works but no LBA48 and "hdparm -t" is slower | Date | Sat, 18 Oct 2008 13:42:48 +0200 |
| |
Hello, big thanks to Alan Cox for the work on pata_it821x driver. I just upgraded to 2.6.27 and my RAID1 on IT8212 controller now works without any patching.
Good that I haven't resized my 30GB partition to full drive capacity yet because LBA48 does not work:
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11 pata_it821x 0000:00:12.0: PCI INT A -> Link[LNKC] -> GSI 11 (level, low) -> IRQ 11 pata_it821x: controller in smart mode. pata_it821x 0000:00:12.0: setting latency timer to 64 pata_it821x: Firmware 02/09/3030 0: MWDMA2 RAID1RAID 0+1 Volume: 0 SAMSUNG HD400LD 1: MWDMA2 RAID1RAID 0+1 Volume: 0 SAMSUNG HD400LD scsi2 : pata_it821x scsi3 : pata_it821x ata3: PATA max UDMA/133 cmd 0x6800 ctl 0x6c00 bmdma 0x7800 irq 11 ata4: PATA max UDMA/133 cmd 0x7000 ctl 0x7400 bmdma 0x7808 irq 11 ata3.00: ATA-4: Integrated Technology Express Inc, , max MWDMA2 ata3.00: 268435455 sectors, multi 0: LBA ^^ no 48 here
ata3.00: RAID1 volume. ata3.00: configured for DMA scsi 2:0:0:0: Direct-Access ATA Integrated Techn n/a PQ: 0 ANSI: 5 sd 2:0:0:0: [sdb] 268435455 512-byte hardware sectors (137439 MB) ^^^^^^ should be 400088
sd 2:0:0:0: [sdb] Write Protect is off sd 2:0:0:0: [sdb] Mode Sense: 00 3a 00 00 sd 2:0:0:0: [sdb] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA sd 2:0:0:0: [sdb] 268435455 512-byte hardware sectors (137439 MB) sd 2:0:0:0: [sdb] Write Protect is off sd 2:0:0:0: [sdb] Mode Sense: 00 3a 00 00 sd 2:0:0:0: [sdb] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA sdb: sdb1 sdb2 sdb3 sdb4 sd 2:0:0:0: [sdb] Attached SCSI disk sd 2:0:0:0: Attached scsi generic sg2 type 0
Also "hdparm -t" is slower (but "hdparm -t --direct" isn't - so it probably isn't pata_it821x issue): 2.6.26 (with my crappy patch): /dev/sdb: Timing buffered disk reads: 60 MB in 3.01 seconds = 19.91 MB/sec
/dev/sdb: Timing O_DIRECT disk reads: 194 MB in 3.00 seconds = 64.62 MB/sec
/dev/sdb:
Model=Integrated Technology Express Inc , FwRev=, SerialNo=▒PX Config={ } RawCHS=0/0/0, TrkSize=0, SectSize=0, ECCbytes=0 BuffType=unknown, BuffSize=0kB, MaxMultSect=0 (maybe): CurCHS=0/0/0, CurSects=0, LBA=no IORDY=no PIO modes: pio0 AdvancedPM=no
* signifies the current active mode
2.6.27: /dev/sdb: Timing buffered disk reads: 48 MB in 3.08 seconds = 15.57 MB/sec
/dev/sdb: Timing O_DIRECT disk reads: 196 MB in 3.02 seconds = 64.81 MB/sec
/dev/sdb:
Model=Integrated Technology Express Inc , FwRev=, SerialNo=▒'T Config={ } RawCHS=0/0/0, TrkSize=0, SectSize=0, ECCbytes=0 BuffType=unknown, BuffSize=0kB, MaxMultSect=0 (maybe): CurCHS=0/0/0, CurSects=0, LBA=yes, LBAsects=781422766 IORDY=no PIO modes: pio0 DMA modes: mdma0 mdma1 mdma2 AdvancedPM=no Drive conforms to: Unspecified: ATA/ATAPI-0,1,2,3,4
* signifies the current active mode
-- Ondrej Zary -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |