lkml.org 
[lkml]   [2008]   [Jan]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH: 1/2] [SERIAL] avoid waking up closed serial ports on resume
When we boot, serial ports remain in low power mode until they're
used either by userspace or for the kernel console.

However, if you suspend the system, and then resume, all serial ports
will be taken out of low power mode. This is bad news for embedded
devices where this can mean higher power consumption.

Only bring a serial port out of low power mode if the port is being
used as the kernel console, or is in use by userspace.

Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

diff --git a/drivers/serial/serial_core.c b/drivers/serial/serial_core.c
index 3bb5d24..80486c6 100644
--- a/drivers/serial/serial_core.c
+++ b/drivers/serial/serial_core.c
@@ -2029,8 +2029,6 @@ int uart_resume_port(struct uart_driver *drv, struct uart_port *port)
}
port->suspended = 0;

- uart_change_pm(state, 0);
-
/*
* Re-enable the console device after suspending.
*/
@@ -2049,6 +2047,7 @@ int uart_resume_port(struct uart_driver *drv, struct uart_port *port)
if (state->info && state->info->tty && termios.c_cflag == 0)
termios = *state->info->tty->termios;

+ uart_change_pm(state, 0);
port->ops->set_termios(port, &termios, NULL);
console_start(port->cons);
}
@@ -2057,6 +2056,7 @@ int uart_resume_port(struct uart_driver *drv, struct uart_port *port)
const struct uart_ops *ops = port->ops;
int ret;

+ uart_change_pm(state, 0);
ops->set_mctrl(port, 0);
ret = ops->startup(port);
if (ret == 0) {
--
Russell King
Linux kernel 2.6 ARM Linux - http://www.arm.linux.org.uk/
maintainer of:


\
 
 \ /
  Last update: 2008-01-08 12:59    [W:1.182 / U:0.108 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site