lkml.org 
[lkml]   [2008]   [Jan]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: JMicron PATA 2.6.24-rc7 can't find drives
Lennart Sorensen wrote:
> On Thu, Jan 24, 2008 at 03:30:44PM +0100, Marcin Gil wrote:
>> This is not a problem. I've posted (in original mail) that DVD is found
>> fine (and linked as /dev/cdrom). But I have a Maxtor HDD on the same
>> ide-tape and it is not detected at all.
>
> Are you using an 80 pin IDE cable and are both drives set to cable
> select (usually preferable) or is one master and one slave?
>
Yes, this is 80-wire cable; both are connected on the same cable. HDD is
master and DVD is slave. I'll later try disconnecting DVD and see what
happens. I didn't set cable-select due to how these drives are connected

+-----+-----+
mobo hdd dvd

I think that cable select would take dvd as master and hdd as slave.
This was not preferable when hdd was my primary drive. I can try
cable-select now since I boot off new SATA drive.

Thank you,
-Marcin Gil



\
 
 \ /
  Last update: 2008-01-24 15:51    [W:0.151 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site