lkml.org 
[lkml]   [2007]   [Aug]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    SubjectRe: Linux 2.6.23-rc3
    From
    Date
    Hello, 

    I have also noticed that there are other messages printed twice, not a
    big problem but still ;) . Perhaps it should be that way, don't know.

    $ dmesg | grep sda
    sd 0:0:0:0: [sda] 234441648 512-byte hardware sectors (120034 MB)
    sd 0:0:0:0: [sda] Write Protect is off
    sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
    sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
    sd 0:0:0:0: [sda] 234441648 512-byte hardware sectors (120034 MB)
    sd 0:0:0:0: [sda] Write Protect is off
    sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
    sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA


    Inserting USB key also has the same behavior:

    Initializing USB Mass Storage driver...
    scsi6 : SCSI emulation for USB Mass Storage devices
    usbcore: registered new interface driver usb-storage
    USB Mass Storage support registered.
    usb-storage: device found at 4
    usb-storage: waiting for device to settle before scanning
    usb-storage: device scan complete
    scsi 6:0:0:0: Direct-Access USB 2.0 Flash Disk 1100 PQ: 0 ANSI: 0 CCS
    sd 6:0:0:0: [sdb] 4062208 512-byte hardware sectors (2080 MB)
    sd 6:0:0:0: [sdb] Write Protect is off
    sd 6:0:0:0: [sdb] Mode Sense: 43 00 00 00
    sd 6:0:0:0: [sdb] Assuming drive cache: write through
    sd 6:0:0:0: [sdb] 4062208 512-byte hardware sectors (2080 MB)
    sd 6:0:0:0: [sdb] Write Protect is off
    sd 6:0:0:0: [sdb] Mode Sense: 43 00 00 00
    sd 6:0:0:0: [sdb] Assuming drive cache: write through
    sdb: sdb1
    sd 6:0:0:0: [sdb] Attached SCSI removable disk
    sd 6:0:0:0: Attached scsi generic sg2 type 0

    On Mon, 2007-08-13 at 15:23 +0300, Zilvinas Valinskas wrote:
    > Hello lkml,
    >
    > Linux kernel v2.6.23-rc3 booted ok and so far everything is fine. I have
    > HP Compaq nx9420 laptop (Dual Core).
    >
    > Just a few things that I found interesting:
    >
    > 1. /sys/devices/system/clocksource/clocksource0/*
    >
    > $ sudo grep . *
    > available_clocksource:hpet hpet acpi_pm jiffies tsc
    > ^^^^^^^^^ listed twice ;) not a big deal but still.
    > current_clocksource:hpet
    > ^^^^ seems selected ;) although in dmesg there are
    >
    > $ dmesg | grep -i hpet
    > $ dmesg | grep -i hpet
    > ACPI: HPET 7FFE59BC, 0038 (r1 HP 309F 1 HP 1)
    > ACPI: HPET id: 0x8086a201 base: 0xfed00000
    > hpet0: at MMIO 0xfed00000, IRQs 2, 8, 0
    > hpet0: 3 64-bit timers, 14318180 Hz
    > hpet_resources: 0xfed00000 is busy
    > ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ ? strange.
    >
    > Time: hpet clocksource has been installed.
    >
    > 2. ACPI related (?) - one fan is always on, even when system is idling.
    >
    > It never stops ;)
    >
    > $ acpi -bt
    > Battery 1: charged, 98%
    > Thermal 1: ok, 48.0 degrees C
    > Thermal 2: ok, 38.0 degrees C
    > Thermal 3: active[5], 47.0 degrees C
    > Thermal 4: ok, 37.0 degrees C
    > Thermal 5: ok, 32.0 degrees C
    > Thermal 6: ok, 25.0 degrees C
    >
    >
    > In earlier kernel versions it was turned on when needed (mostly during
    > compilation ...) and then when system is cooled enough fan was
    > automatically turned off.
    >
    > 3. the same messages are printed twice (2.6.23-rc2 was fine).
    >
    > Brought up 2 CPUs
    > NET: Registered protocol family 16
    > ACPI: bus type pci registered
    > PCI: BIOS Bug: MCFG area at f8000000 is not E820-reserved
    > PCI: Not using MMCONFIG.
    > PCI: Using configuration type 1
    > ACPI: EC: Look up EC in DSDT
    > ACPI: EC: GPE = 0x16, I/O: command/status = 0x66, data = 0x62
    > ^^^^^^^^^^^^^^^^^^^^^^^^ 1st time
    > ACPI: Interpreter enabled
    > ACPI: (supports S0 S3)
    > ACPI: Using IOAPIC for interrupt routing
    > ACPI: EC: GPE = 0x16, I/O: command/status = 0x66, data = 0x62
    > ^^^^^^^^^^^^^^^^^^^^^^^^ 2nd time
    > ACPI: PCI Root Bridge [C003] (0000:00)
    >
    >
    > Otherwise I am happy with 2.6.23-rc3. Thank y'all ;)
    >
    > Best regards,
    > Zilvinas
    >
    >
    > -
    > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    > the body of a message to majordomo@vger.kernel.org
    > More majordomo info at http://vger.kernel.org/majordomo-info.html
    > Please read the FAQ at http://www.tux.org/lkml/

    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.kernel.org
    More majordomo info at http://vger.kernel.org/majordomo-info.html
    Please read the FAQ at http://www.tux.org/lkml/

    \
     
     \ /
      Last update: 2007-08-14 12:19    [W:0.033 / U:2.160 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site