Messages in this thread | | | Date | Mon, 15 Jan 2007 13:00:20 -0600 | From | Jay Cliburn <> | Subject | Re: [PATCH] Add suport for Marvell 88SE6121 in pata_marvell |
| |
Jose Alberto Reguero wrote: > Marvell 88SE6121
[snip]
> ------------------------------------------------------------------------ > > --- linux-2.6.20-rc3/drivers/ata/pata_marvell.c 2007-01-01 01:53:20.000000000 +0100 > +++ linux-2.6.20-rc3.new/drivers/ata/pata_marvell.c 2007-01-06 12:33:03.000000000 +0100 > @@ -49,7 +49,7 @@
[snip]
Works-for-me: Jay Cliburn <jacliburn@bellsouth.net>
The following dmesg snippet after applying the patch shows life from the hitherto unsupported device: (I connected an unpartitioned SATA HDD to it.) ============== [ 39.789326] PCI: Setting latency timer of device 0000:06:00.0 to 64 [ 39.789436] ata3: PATA max UDMA/100 cmd 0xEC00 ctl 0xE882 bmdma 0xE400 irq 28 [ 39.789541] ata4: PATA max UDMA/133 cmd 0xE800 ctl 0xE482 bmdma 0xE408 irq 28 [ 39.789559] scsi2 : pata_marvell [ 39.790121] BAR5:00:02 01:7F 02:22 03:CA 04:00 05:00 06:00 07:00 08:00 09:00 0A:00 0B:00 0C:07 0D:00 0E:00 0F:00 [ 39.790152] ata3: port disabled. ignoring. [ 39.790154] ata3: reset failed, giving up [ 39.790161] scsi3 : pata_marvell [ 39.790589] BAR5:00:02 01:7F 02:22 03:CA 04:00 05:00 06:00 07:00 08:00 09:00 0A:00 0B:00 0C:07 0D:00 0E:00 0F:00 [ 39.958055] ATA: abnormal status 0x7F on port 0xE807 [ 39.968869] ATA: abnormal status 0x7F on port 0xE807 [ 39.979450] ata4.00: ATA-7, max UDMA/133, 488397168 sectors: LBA48 [ 39.979453] ata4.00: ata4: dev 0 multi count 16 [ 39.987443] ata4.00: configured for UDMA/133 [ 39.987628] scsi 3:0:0:0: Direct-Access ATA WDC WD2500KS-00M 02.0 PQ: 0 ANSI: 5 [ 39.988524] SCSI device sdb: 488397168 512-byte hdwr sectors (250059 MB) [ 39.988546] sdb: Write Protect is off [ 39.988548] sdb: Mode Sense: 00 3a 00 00 [ 39.988583] SCSI device sdb: write cache: enabled, read cache: enabled, doesn't support DPO or FUA [ 39.988695] SCSI device sdb: 488397168 512-byte hdwr sectors (250059 MB) [ 39.988713] sdb: Write Protect is off [ 39.988715] sdb: Mode Sense: 00 3a 00 00 [ 39.988749] SCSI device sdb: write cache: enabled, read cache: enabled, doesn't support DPO or FUA [ 39.988781] sdb: unknown partition table [ 39.994867] sd 3:0:0:0: Attached scsi disk sdb [ 39.994990] sd 3:0:0:0: Attached scsi generic sg1 type 0
This is the relevant portion of lspci: ============== 06:00.0 SATA controller: Marvell Technology Group Ltd. Unknown device 6121 (rev b0) (prog-if 8f) Subsystem: ASUSTeK Computer Inc. Unknown device 8212 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 0, Cache Line Size: 64 bytes Interrupt: pin A routed to IRQ 28 Region 0: I/O ports at ec00 [size=8] Region 1: I/O ports at e880 [size=4] Region 2: I/O ports at e800 [size=8] Region 3: I/O ports at e480 [size=4] Region 4: I/O ports at e400 [size=16] Region 5: Memory at fbeffc00 (32-bit, non-prefetchable) [size=1K] Capabilities: [48] Power Management version 2 Flags: PMEClk- DSI- D1+ D2- AuxCurrent=0mA PME(D0+,D1+,D2-,D3hot+,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=1 PME- Capabilities: [50] Message Signalled Interrupts: 64bit- Queue=0/0 Enable - Address: 00000000 Data: 0000 Capabilities: [e0] Express Legacy Endpoint IRQ 0 Device: Supported: MaxPayload 128 bytes, PhantFunc 0, ExtTag- Device: Latency L0s unlimited, L1 unlimited Device: AtnBtn- AtnInd- PwrInd- Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported- Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr+ NoSnoop- Device: MaxPayload 128 bytes, MaxReadReq 512 bytes Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s, Port 1 Link: Latency L0s <256ns, L1 unlimited Link: ASPM Disabled RCB 64 bytes CommClk- ExtSynch- Link: Speed 2.5Gb/s, Width x1 00: ab 11 21 61 07 01 10 00 b0 8f 06 01 10 00 00 00 10: 01 ec 00 00 81 e8 00 00 01 e8 00 00 81 e4 00 00 20: 01 e4 00 00 00 fc ef fb 00 00 00 00 43 10 12 82 30: 00 00 00 00 48 00 00 00 00 00 00 00 0b 01 00 00 40: 24 c9 c0 00 1f 80 00 00 01 50 02 5a 00 20 00 13 50: 05 e0 00 00 00 00 00 00 00 00 00 00 00 00 00 00 60: 58 c4 21 40 b0 00 00 00 00 00 00 00 00 00 00 00 70: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 80: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 e0: 10 00 11 00 c0 0f 18 00 00 24 08 00 11 a4 03 01 f0: 00 00 11 10 00 00 00 00 00 00 00 00 00 00 00 00
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |