lkml.org 
[lkml]   [2007]   [Jan]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH] libata: PIIX3 support
This I believe completes the PIIX range of support for libata

This adds the table entries needed for the PIIX3, both a new PCI
identifier and a new mode list. It also fixes an erroneous access to PCI
configuration 0x48 on non UDMA capable chips.

Signed-off-by: Alan Cox <alan@redhat.com>

--- linux.vanilla-2.6.20-rc3-mm1/drivers/ata/ata_piix.c 2007-01-05 13:09:36.000000000 +0000
+++ linux-2.6.20-rc3-mm1/drivers/ata/ata_piix.c 2007-01-10 16:37:56.840128000 +0000
@@ -118,7 +118,7 @@
PIIX_80C_SEC = (1 << 7) | (1 << 6),

/* controller IDs */
- piix_pata_33 = 0, /* PIIX3 or 4 at 33Mhz */
+ piix_pata_33 = 0, /* PIIX4 at 33Mhz */
ich_pata_33 = 1, /* ICH up to UDMA 33 only */
ich_pata_66 = 2, /* ICH up to 66 Mhz */
ich_pata_100 = 3, /* ICH up to UDMA 100 */
@@ -128,6 +128,7 @@
ich6_sata_ahci = 7,
ich6m_sata_ahci = 8,
ich8_sata_ahci = 9,
+ piix_pata_mwdma = 10, /* PIIX3 MWDMA only */

/* constants for mapping table */
P0 = 0, /* port 0 */
@@ -165,6 +166,8 @@

static const struct pci_device_id piix_pci_tbl[] = {
#ifdef ATA_ENABLE_PATA
+ /* Intel PIIX3 for the 430HX etc */
+ { 0x8086, 0x7010, PCI_ANY_ID, PCI_ANY_ID, 0, 0, piix_pata_mwdma },
/* Intel PIIX4 for the 430TX/440BX/MX chipset: UDMA 33 */
/* Also PIIX4E (fn3 rev 2) and PIIX4M (fn3 rev 3) */
{ 0x8086, 0x7111, PCI_ANY_ID, PCI_ANY_ID, 0, 0, piix_pata_33 },
@@ -441,7 +444,7 @@
};

static struct ata_port_info piix_port_info[] = {
- /* piix_pata_33: 0: PIIX3 or 4 at 33MHz */
+ /* piix_pata_33: 0: PIIX4 at 33MHz */
{
.sht = &piix_sht,
.flags = PIIX_PATA_FLAGS,
@@ -543,6 +546,14 @@
.port_ops = &piix_sata_ops,
},

+ /* piix_pata_mwdma: 10: PIIX3 MWDMA only */
+ {
+ .sht = &piix_sht,
+ .flags = PIIX_PATA_FLAGS,
+ .pio_mask = 0x1f, /* pio0-4 */
+ .mwdma_mask = 0x06, /* mwdma1-2 ?? CHECK 0 should be ok but slow */
+ .port_ops = &piix_pata_ops,
+ },
};

static struct pci_bits piix_enable_bits[] = {
@@ -786,7 +797,8 @@
{ 2, 3 }, };

pci_read_config_word(dev, master_port, &master_data);
- pci_read_config_byte(dev, 0x48, &udma_enable);
+ if (ap->udma_mask)
+ pci_read_config_byte(dev, 0x48, &udma_enable);

if (speed >= XFER_UDMA_0) {
unsigned int udma = adev->dma_mode - XFER_UDMA_0;
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
\
 
 \ /
  Last update: 2007-01-10 18:45    [W:0.246 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site