lkml.org 
[lkml]   [2006]   [Sep]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: 2.6.18-rc7-mm1: networking breakage on HPC nx6325 + SUSE 10.1
From
Date
On Tue, 19 Sep 2006 23:30:34 +0200, "Rafael J. Wysocki" said:

> Well, I can configure the interfaces manually, with ifconfig, but the SUSE's
> configuration tools don't work. For example, "ifup eth0" tells me that
> "No configuration found for eth0" and that's all.

I'm seeing issues on a Dell Latitude C840 as well, but I'm not positive
it's the same bug(s). The problem I'm seeing is that device renaming is
failing (I have up to 5 different ethernet-ish interfaces that can be
connected, so I abuse /sbin/nameif extensively. There seem to be some
other issues with pcmcia, but it's not clear what the problem is - it
manages to find the (normally down) ethernet on my Xircom card, but the
orinoco driver seems unable to find my wireless card....

For instance, under 2.6.18-rc6-mm2, I see:

pccard: CardBus card inserted into slot 0
PCI: Enabling device 0000:03:00.0 (0000 -> 0003)
ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:03:00.0 to 64
eth2: Xircom cardbus revision 3 at irq 11
PCI: Enabling device 0000:03:00.1 (0000 -> 0003)
ACPI: PCI Interrupt 0000:03:00.1[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
0000:03:00.1: ttyS1 at I/O 0xe080 (irq = 11) is a 16550A
pccard: PCMCIA card inserted into slot 2
[rename_device:851]: Changing netdevice name from [eth1] to [eth3]
ohci1394: fw-host0: AT dma reset ctx=0, aborting transmission
ieee1394: Current remote IRM is not 1394a-2000 compliant, resetting...
ieee1394: Host added: ID:BUS[0-00:1023] GUID[374fc0002a71c021]
[rename_device:1237]: Changing netdevice name from [eth2] to [eth1]
cs: memory probe 0xf4000000-0xfbffffff: excluding 0xf4000000-0xf8ffffff 0xfa000000-0xfbffffff
pcmcia: registering new device pcmcia2.0
orinoco 0.15 (David Gibson <hermes@gibson.dropbear.id.au>, Pavel Roskin <proski@gnu.org>, et al)
orinoco_cs 0.15 (David Gibson <hermes@gibson.dropbear.id.au>, Pavel Roskin <proski@gnu.org>, et al)
pcmcia: request for exclusive IRQ could not be fulfilled.
pcmcia: the driver needs updating to supported shared IRQ lines.
cs: IO port probe 0x100-0x3af: excluding 0x370-0x37f
cs: IO port probe 0x3e0-0x4ff: clean.
cs: IO port probe 0x820-0x8ff: clean.
cs: IO port probe 0xc00-0xcf7: clean.
cs: IO port probe 0xa00-0xaff: clean.
cs: IO port probe 0x100-0x3af: excluding 0x370-0x37f
cs: IO port probe 0x3e0-0x4ff: clean.
cs: IO port probe 0x820-0x8ff: clean.
cs: IO port probe 0xc00-0xcf7: clean.
cs: IO port probe 0xa00-0xaff: clean.
cs: IO port probe 0x100-0x3af: excluding 0x370-0x37f
cs: IO port probe 0x3e0-0x4ff: clean.
cs: IO port probe 0x820-0x8ff: clean.
cs: IO port probe 0xc00-0xcf7: clean.
cs: IO port probe 0xa00-0xaff: clean.
eth2: Hardware identity 0005:0004:0005:0000
eth2: Station identity 001f:0001:0008:000a
eth2: Firmware determined as Lucent/Agere 8.10
eth2: Ad-hoc demo mode supported
eth2: IEEE standard IBSS ad-hoc mode supported
eth2: WEP supported, 104-bit key
eth2: MAC address 00:02:2D:5C:11:48
eth2: Station name "HERMES I"
eth2: ready
eth2: orinoco_cs at 2.0, irq 11, io 0xe100-0xe13f
[rename_device:1295]: Changing netdevice name from [eth2] to [eth5]
Non-volatile memory driver v1.2

and under -rc7-mm1, I see:

pccard: CardBus card inserted into slot 0
PCI: Enabling device 0000:03:00.0 (0000 -> 0003)
ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:03:00.0 to 64
eth1: Xircom cardbus revision 3 at irq 11
PCI: Enabling device 0000:03:00.1 (0000 -> 0003)
ACPI: PCI Interrupt 0000:03:00.1[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
0000:03:00.1: ttyS1 at I/O 0xe080 (irq = 11) is a 16550A
pccard: PCMCIA card inserted into slot 2
ohci1394: fw-host0: AT dma reset ctx=0, aborting transmission
ieee1394: Current remote IRM is not 1394a-2000 compliant, resetting...
ieee1394: Host added: ID:BUS[0-00:1023] GUID[374fc0002a71c021]
Non-volatile memory driver v1.2

Amazingly less chatty. Much later, when /etc/rc5.d/S10network runs, we finally
see:

orinoco 0.15 (David Gibson <hermes@gibson.dropbear.id.au>, Pavel Roskin <proski@gnu.org>, et al)
orinoco_cs 0.15 (David Gibson <hermes@gibson.dropbear.id.au>, Pavel Roskin <proski@gnu.org>, et al)

but no output for the wireless configuring.

Unless somebody has a better idea overnight, I'll start a bisect of -rc7-mm1
in the morning...

[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2006-09-20 03:07    [W:0.145 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site