Messages in this thread |  | | From | Pete Clements <> | Subject | Re: Correction: 2.6.16-git12 killed networking -- 3c900 card | Date | Tue, 28 Mar 2006 11:44:54 -0500 (EST) |
| |
Quoting Steffen Klassert > > > > FYI: > > Single 3c900 card, UP i386 > > Lost networking with .16-git12, message > > ADDRCONF(NETDEV_UP): eth0: link is not ready > > This could be due to the recent driver update. > I can not reproduce this with a 3c900B-Combo, > so I need some more information to track it down.
Data attached. Note: 1) Using coax 10base2. 2) Driver is compiled in, not a module. If you need I'll recompile with debug set. > > > Had several of these with git11 > > NETDEV WATCHDOG: eth0: transmit timed out > > Is this for sure that these messages occured first time with git11? > There were no changes in the 3c59x driver between git10 and git11.
Only occurrance in git11, 4 hits during a local net ftp. Low network load system.
> > > > > No problems observed git1-git10 > > > > If you are willing to provide me with some information > you can send the following: > > 1. output of lspci -vvv (just the ethernet controller related part) > > 2. your Kernel configuration > > 3. modprobe the driver with debug=4 and send > the 3c59x related lines of your logs for both, git11 and git12. > (From driver startup about 15 seconds should be sufficiant for now) > > 4. the output of "vortex-diag -aem" and "mii-diag". > You can find these tools at http://www.scyld.com/ethercard_diag.html > > > Steffen > -
-- Pete Clements [unhandled content-type:application/octet-stream] |  |