lkml.org 
[lkml]   [2006]   [Dec]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
Subjectcypress_m8 spews garbage on ppc64 but is ok on x86
anyone tried using the cypress_m8 usb serial cable on a G5 ?  just
tried it on a ppc64/2.6.19.1 kernel and all i get back is garbage when
hooked up to serial console of a board running at 57600 baud

plugged the same cable into my x86 machine and it works OK there
Bus 001 Device 010: ID 04b4:5500 Cypress Semiconductor Corp. HID->COM
RS232 Adapter

plugged a pl2303 into the ppc64 and that worked fine too
Bus 001 Device 011: ID 067b:2303 Prolific Technology, Inc. PL2303 Serial Port

$ uname -a
Linux G5 2.6.19.1 #2 SMP Sun Dec 24 00:53:03 EST 2006 ppc PPC970MP,
altivec supported PowerMac11,2 GNU/Linux

$ stty -F /dev/ttyUSB0
speed 57600 baud; line = 0;
flush = ^U; min = 1; time = 5;
ignbrk -brkint -icrnl ixoff -imaxbel
-opost -onlcr
-isig -icanon -iexten -echo -echoe -echok -echoctl -echoke

find attached logs after doing `modprobe cypress_m8 debug=1`
* setup of /dev/ttyUSB0 to proper serial settings
* the board running `yes` and spewing "y" over the serial console to my machine
-mike
[unhandled content-type:application/x-bzip2][unhandled content-type:application/x-bzip2]
\
 
 \ /
  Last update: 2006-12-24 08:01    [W:0.022 / U:0.376 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site