lkml.org 
[lkml]   [2006]   [Nov]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: 2.6.19-rc5 x86_64 irq 22: nobody cared
On Wed, Nov 08, 2006 at 01:44:29PM +0100, Olivier Nicolas wrote:

> Hi,

Hi Olivier,

> 2.6.19-rc5 does not boot properly, I have tried pci=routeirq, irpoll
> without success.
>
> Full details (.config, dmesg, /proc/interrupts) are in
> http://olivn.trollprod.org/2.6.19-rc5-irq.tar.gz

thanks for your report!

I might be wrong, but looking at the dmesg:
- irq 22 is the hda_intel IRQ
- the "irq 22: nobody cared" is immediately before the
"hda_intel: No response from codec, disabling MSI..."
- in the routeirq case, the hda_intel IRQ as well as the
IRQ in the error message change to 21

So it might be related to the hda_intel MSI check.

If this was a wrong guess, other interesting messages in the dmesg are:

<-- snip -->

...
PCI: Using MMCONFIG at f0000000
PCI: No mmconfig possible on device 00:18
...
PCI: Setting latency timer of device 0000:00:03.0 to 64
pcie_portdrv_probe->Dev[02fd:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:03.0:pcie00]
Allocate Port Service[0000:00:03.0:pcie03]
PCI: Setting latency timer of device 0000:00:04.0 to 64
pcie_portdrv_probe->Dev[02fb:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:04.0:pcie00]
Allocate Port Service[0000:00:04.0:pcie03]
PCI: Setting latency timer of device 0000:00:12.0 to 64
pcie_portdrv_probe->Dev[0376:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:12.0:pcie00]
Allocate Port Service[0000:00:12.0:pcie03]
PCI: Setting latency timer of device 0000:00:14.0 to 64
pcie_portdrv_probe->Dev[0374:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:14.0:pcie00]
Allocate Port Service[0000:00:14.0:pcie03]
PCI: Setting latency timer of device 0000:00:16.0 to 64
pcie_portdrv_probe->Dev[0375:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:16.0:pcie00]
Allocate Port Service[0000:00:16.0:pcie03]
PCI: Setting latency timer of device 0000:00:17.0 to 64
pcie_portdrv_probe->Dev[0377:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:17.0:pcie00]
Allocate Port Service[0000:00:17.0:pcie03]
...

<-- snip -->

> Olivier
>
> System: ASUS M2N32-SLI, AMD64 X2 Dual Core 4600
>
>
> kernel 2.6.9-rc5
>
> irq 22: nobody cared (try booting with the "irqpoll" option)
>
> Call Trace:
> <IRQ> [<ffffffff80259055>] __report_bad_irq+0x35/0x90
> [<ffffffff802592d3>] note_interrupt+0x223/0x280
> [<ffffffff80259d41>] handle_fasteoi_irq+0xb1/0xf0
> [<ffffffff8020b17c>] call_softirq+0x1c/0x30
> [<ffffffff8020d1ba>] do_IRQ+0x8a/0xe0
> [<ffffffff8020a571>] ret_from_intr+0x0/0xa
> <EOI>
> handlers:
> [<ffffffff8807f150>] (nv_generic_interrupt+0x0/0xc0 [sata_nv])
> Disabling IRQ #22
>
>
> CPU0 CPU1
> 0: 223 45540 IO-APIC-edge timer
> 1: 1 402 IO-APIC-edge i8042
> 6: 1 4 IO-APIC-edge floppy
> 8: 0 0 IO-APIC-edge rtc
> 9: 0 0 IO-APIC-fasteoi acpi
> 12: 0 103 IO-APIC-edge i8042
> 14: 7 140 IO-APIC-edge ide0
> 16: 0 0 IO-APIC-fasteoi libata
> 17: 0 10 IO-APIC-fasteoi bttv0
> 20: 0 20 IO-APIC-fasteoi ehci_hcd:usb1
> 21: 0 0 IO-APIC-fasteoi libata
> 22: 214 99786 IO-APIC-fasteoi libata, HDA Intel
> 23: 76 6230 IO-APIC-fasteoi libata, ohci_hcd:usb2
> 308: 5 3169 PCI-MSI-edge eth1
> 309: 0 10 PCI-MSI-edge eth1
> 310: 0 44 PCI-MSI-edge eth1
> 311: 1 3193 PCI-MSI-edge eth0
> 312: 0 0 PCI-MSI-edge eth0
> 313: 0 1 PCI-MSI-edge eth0
> NMI: 64 68
> LOC: 45716 45691
> ERR: 0
>
>
>
> kernel 2.6.19-rc5 with pci=routeirq
>
> irq 21: nobody cared (try booting with the "irqpoll" option)
>
> Call Trace:
> <IRQ> [<ffffffff80259055>] __report_bad_irq+0x35/0x90
> [<ffffffff802592d3>] note_interrupt+0x223/0x280
> [<ffffffff80259d41>] handle_fasteoi_irq+0xb1/0xf0
> [<ffffffff8020b17c>] call_softirq+0x1c/0x30
> [<ffffffff8020d1ba>] do_IRQ+0x8a/0xe0
> [<ffffffff802092f0>] default_idle+0x0/0x50
> [<ffffffff8020a571>] ret_from_intr+0x0/0xa
> <EOI> [<ffffffff80209319>] default_idle+0x29/0x50
> [<ffffffff8020939b>] cpu_idle+0x5b/0x80
> [<ffffffff8050039c>] start_secondary+0x50c/0x520
>
> handlers:
> [<ffffffff880e6fd0>] (usb_hcd_irq+0x0/0x60 [usbcore])
> Disabling IRQ #21
>
> CPU0 CPU1
> 0: 214 24856 IO-APIC-edge timer
> 1: 0 359 IO-APIC-edge i8042
> 6: 0 5 IO-APIC-edge floppy
> 8: 0 0 IO-APIC-edge rtc
> 9: 0 0 IO-APIC-fasteoi acpi
> 12: 0 103 IO-APIC-edge i8042
> 14: 0 128 IO-APIC-edge ide0
> 16: 0 0 IO-APIC-fasteoi libata
> 17: 1 2 IO-APIC-fasteoi bttv0
> 20: 22 6469 IO-APIC-fasteoi libata
> 21: 11 99989 IO-APIC-fasteoi ehci_hcd:usb2, HDA Intel
> 22: 0 1 IO-APIC-fasteoi libata, ohci_hcd:usb1
> 23: 0 0 IO-APIC-fasteoi libata
> 308: 8 2378 PCI-MSI-edge eth1
> 309: 0 9 PCI-MSI-edge eth1
> 310: 0 9 PCI-MSI-edge eth1
> 311: 4 2401 PCI-MSI-edge eth0
> 312: 0 0 PCI-MSI-edge eth0
> 313: 0 1 PCI-MSI-edge eth0
> NMI: 74 47
> LOC: 25024 24991
> ERR: 0
>
>
>
> kernel 2.6.19-rc5 with irqpoll
>
> Hang during boot
> (See screenshot in http://olivn.trollprod.org/2.6.19-rc5-irq.tar.gz)
>
>
>
> kernel 2.6.18 (works without any problem)
>
> CPU0 CPU1
> 0: 1590 998089 IO-APIC-edge timer
> 1: 2 657 IO-APIC-edge i8042
> 6: 0 5 IO-APIC-edge floppy
> 8: 0 0 IO-APIC-edge rtc
> 9: 0 0 IO-APIC-level acpi
> 12: 194 59353 IO-APIC-edge i8042
> 14: 13 6381 IO-APIC-edge ide0
> 50: 0 0 IO-APIC-level libata
> 58: 0 0 IO-APIC-level libata
> 66: 109 181425 IO-APIC-level libata, nvidia
> 74: 41 963 IO-APIC-level ehci_hcd:usb1, HDA Intel
> 82: 4 6 IO-APIC-level bttv0
> 90: 0 0 PCI-MSI-X eth0
> 98: 3 0 PCI-MSI-X eth0
> 106: 212234 0 PCI-MSI-X eth0
> 114: 532 0 PCI-MSI-X eth1
> 122: 445 0 PCI-MSI-X eth1
> 130: 212217 0 PCI-MSI-X eth1
> 233: 73 23009 IO-APIC-level libata, ohci_hcd:usb2
> NMI: 99 104
> LOC: 999684 999664
> ERR: 0
> MIS: 0
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2006-11-09 07:53    [W:0.070 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site