lkml.org 
[lkml]   [2006]   [Nov]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: 2.6.18 - AHCI detection pauses excessively
Tejun Heo wrote:
> Hmmm.. Can you try with the attached patch applied? Also, please turn
> on kernel config 'Kernel Hacking -> Show timing info on printks' and
> report boot dmesg.

Looks like you forgot to attach the patch, so I couldn't test it:)
Here's the section with the annoying hang with timing info. I noticed
that there are similar messages repeated later, but without as much
hang, so I've attached the entire dmesg as well, in case it's of any help.

[ 74.774249] scsi2 : ahci
[ 75.232531] ata2: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
[ 105.197121] ata2.00: qc timeout (cmd 0xec)
[ 105.197168] ata2.00: failed to IDENTIFY (I/O error, err_mask=0x104)
[ 113.040691] ata2: port is slow to respond, please be patient (Status
0x80)
[ 135.973052] ata2: port failed to respond (30 secs, Status 0x80)
[ 135.973098] ata2: COMRESET failed (device not ready)
[ 135.973145] ata2: hardreset failed, retrying in 5 secs
[ 141.836829] ata2: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
[ 142.366267] ata2.00: failed to IDENTIFY (I/O error, err_mask=0x100)
[ 143.171270] ata2: SATA link down (SStatus 0 SControl 300)

Berck
\
 
 \ /
  Last update: 2006-11-15 19:25    [W:0.150 / U:0.984 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site