lkml.org 
[lkml]   [2006]   [Oct]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
SubjectRe: [PATCH] s2io: add PCI error recovery support
From
On Fri, Oct 27, 2006 at 07:35:18AM -0400, Ananda Raju wrote:
> Looking at all scenarios I feel the first patch is OK. Can you add the
> watchdog timer fix to first initial patch and resubmit.

Appended below.

> So -- just for grins, I thought to myself, "Maybe I can make
> s2io be the first adapter ever to fully recover without
> a hard reset of the card."

... I couldn't quite make this work. Since the patch below
already works, I didn't see much point exterting myself further.

--linas

This patch adds PCI error recovery support to the
s2io 10-Gigabit ethernet device driver. Third revision,
blocks interrupts and the watchdog.

Tested, seems to work well.

Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
Cc: Raghavendra Koushik <raghavendra.koushik@neterion.com>
Cc: Ananda Raju <Ananda.Raju@neterion.com>
Cc: Wen Xiong <wenxiong@us.ibm.com>

----
drivers/net/s2io.c | 121 +++++++++++++++++++++++++++++++++++++++++++++++++++++
drivers/net/s2io.h | 5 ++
2 files changed, 126 insertions(+)

Index: linux-2.6.19-rc1-git11/drivers/net/s2io.c
===================================================================
--- linux-2.6.19-rc1-git11.orig/drivers/net/s2io.c 2006-10-27 10:49:07.000000000 -0500
+++ linux-2.6.19-rc1-git11/drivers/net/s2io.c 2006-10-27 13:55:01.000000000 -0500
@@ -434,11 +434,18 @@ static struct pci_device_id s2io_tbl[] _

MODULE_DEVICE_TABLE(pci, s2io_tbl);

+static struct pci_error_handlers s2io_err_handler = {
+ .error_detected = s2io_io_error_detected,
+ .slot_reset = s2io_io_slot_reset,
+ .resume = s2io_io_resume,
+};
+
static struct pci_driver s2io_driver = {
.name = "S2IO",
.id_table = s2io_tbl,
.probe = s2io_init_nic,
.remove = __devexit_p(s2io_rem_nic),
+ .err_handler = &s2io_err_handler,
};

/* A simplifier macro used both by init and free shared_mem Fns(). */
@@ -3159,6 +3166,11 @@ static void alarm_intr_handler(struct s2
register u64 val64 = 0, err_reg = 0;
u64 cnt;
int i;
+
+ if ((nic->pdev->error_state != pci_channel_io_normal) &&
+ (nic->pdev->error_state != 0))
+ return;
+
nic->mac_control.stats_info->sw_stat.ring_full_cnt = 0;
/* Handling the XPAK counters update */
if(nic->mac_control.stats_info->xpak_stat.xpak_timer_count < 72000) {
@@ -4171,6 +4183,11 @@ static irqreturn_t s2io_isr(int irq, voi
mac_info_t *mac_control;
struct config_param *config;

+ /* Pretend we handled any irq's from a disconnected card */
+ if ((sp->pdev->error_state != pci_channel_io_normal) &&
+ (sp->pdev->error_state != 0))
+ return IRQ_HANDLED;
+
atomic_inc(&sp->isr_cnt);
mac_control = &sp->mac_control;
config = &sp->config;
@@ -7564,3 +7581,107 @@ static void lro_append_pkt(nic_t *sp, lr
sp->mac_control.stats_info->sw_stat.clubbed_frms_cnt++;
return;
}
+
+/**
+ * s2io_io_error_detected - called when PCI error is detected
+ * @pdev: Pointer to PCI device
+ * @state: The current pci conneection state
+ *
+ * This function is called after a PCI bus error affecting
+ * this device has been detected.
+ */
+static pci_ers_result_t s2io_io_error_detected(struct pci_dev *pdev,
+ pci_channel_state_t state)
+{
+ struct net_device *netdev = pci_get_drvdata(pdev);
+ nic_t *sp = netdev->priv;
+
+ netif_device_detach(netdev);
+
+ if (netif_running(netdev)) {
+ unsigned long flags;
+
+ /* The folowing is an abreviated subset of the
+ * steps taken by s2io_card_down(), avoiding
+ * steps that touch the card itself.
+ */
+ del_timer_sync(&sp->alarm_timer);
+ atomic_set(&sp->card_state, CARD_DOWN);
+
+ /* Kill tasklet. */
+ tasklet_kill(&sp->task);
+
+ /* Free all Tx buffers */
+ spin_lock_irqsave(&sp->tx_lock, flags);
+ free_tx_buffers(sp);
+ spin_unlock_irqrestore(&sp->tx_lock, flags);
+
+ /* Free all Rx buffers */
+ spin_lock_irqsave(&sp->rx_lock, flags);
+ free_rx_buffers(sp);
+ spin_unlock_irqrestore(&sp->rx_lock, flags);
+
+ clear_bit(0, &(sp->link_state));
+ sp->device_close_flag = TRUE; /* Device is shut down. */
+ }
+ pci_disable_device(pdev);
+
+ return PCI_ERS_RESULT_NEED_RESET;
+}
+
+/**
+ * s2io_io_slot_reset - called after the pci bus has been reset.
+ * @pdev: Pointer to PCI device
+ *
+ * Restart the card from scratch, as if from a cold-boot.
+ * At this point, the card has exprienced a hard reset,
+ * followed by fixups by BIOS, and has its config space
+ * set up identically to what it was at cold boot.
+ */
+static pci_ers_result_t s2io_io_slot_reset(struct pci_dev *pdev)
+{
+ struct net_device *netdev = pci_get_drvdata(pdev);
+ nic_t *sp = netdev->priv;
+
+ if (pci_enable_device(pdev)) {
+ printk(KERN_ERR "s2io: "
+ "Cannot re-enable PCI device after reset.\n");
+ return PCI_ERS_RESULT_DISCONNECT;
+ }
+
+ pci_set_master(pdev);
+ s2io_reset(sp);
+
+ return PCI_ERS_RESULT_RECOVERED;
+}
+
+/**
+ * s2io_io_resume - called when traffic can start flowing again.
+ * @pdev: Pointer to PCI device
+ *
+ * This callback is called when the error recovery driver tells
+ * us that its OK to resume normal operation.
+ */
+static void s2io_io_resume(struct pci_dev *pdev)
+{
+ struct net_device *netdev = pci_get_drvdata(pdev);
+ nic_t *sp = netdev->priv;
+
+ if (netif_running(netdev)) {
+ if (s2io_card_up(sp)) {
+ printk(KERN_ERR "s2io: "
+ "Can't bring device back up after reset.\n");
+ return;
+ }
+
+ if (s2io_set_mac_addr(netdev, netdev->dev_addr) == FAILURE) {
+ s2io_card_down(sp);
+ printk(KERN_ERR "s2io: "
+ "Can't resetore mac addr after reset.\n");
+ return;
+ }
+ }
+
+ netif_device_attach(netdev);
+ netif_wake_queue(netdev);
+}
Index: linux-2.6.19-rc1-git11/drivers/net/s2io.h
===================================================================
--- linux-2.6.19-rc1-git11.orig/drivers/net/s2io.h 2006-10-27 10:49:07.000000000 -0500
+++ linux-2.6.19-rc1-git11/drivers/net/s2io.h 2006-10-27 10:50:53.000000000 -0500
@@ -1013,6 +1013,11 @@ static void queue_rx_frame(struct sk_buf
static void update_L3L4_header(nic_t *sp, lro_t *lro);
static void lro_append_pkt(nic_t *sp, lro_t *lro, struct sk_buff *skb, u32 tcp_len);

+static pci_ers_result_t s2io_io_error_detected(struct pci_dev *pdev,
+ pci_channel_state_t state);
+static pci_ers_result_t s2io_io_slot_reset(struct pci_dev *pdev);
+static void s2io_io_resume(struct pci_dev *pdev);
+
#define s2io_tcp_mss(skb) skb_shinfo(skb)->gso_size
#define s2io_udp_mss(skb) skb_shinfo(skb)->gso_size
#define s2io_offload_type(skb) skb_shinfo(skb)->gso_type
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2006-10-27 21:35    [W:0.047 / U:0.088 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site