[lkml]   [2005]   [Mar]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: How's the nforce4 support in Linux?
    On Saturday, 26. March 2005 18:32, Marcin Dalecki wrote:
    > On 2005-03-26, at 16:19, Arjan van de Ven wrote:
    > > `
    > >
    > >> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
    > >> hda: dma_intr: error=0x84 { DriveStatusError BadCRC
    > >
    > > BadCRC is 99% sure a cabling issue; either a bad/overheated cable or a
    > > cable used at too high a speed for the cable.
    > No. It is more likely that the timing programming between the disk and
    > host controller
    > are in a miss-match state. UDMA mode detection can come in to mind too.
    > It makes sense to experiment with hdparm to see if the problem goes
    > away in non
    > Ultra DMA modes.

    Thanks, I tried the cable that came with the drive (it was still sealed) and
    experimented a little bit with hdparm...
    Now, the problem seems to be gone...
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    More majordomo info at
    Please read the FAQ at

     \ /
      Last update: 2005-04-06 13:30    [W:0.021 / U:5.416 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site