lkml.org 
[lkml]   [2004]   [May]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject2.6.6-rc3 MCA at bootup on rx2600
Date
Hi,

I got MCA while booting 2.6.6-rc3 on a 2 cpu rx2600.
The following is the screen dump till it stops.

=============== SOME MCA dump =====================
**** CPU Error Information, CPU00 ****
Time Stamp: 05/05/2004 at 14:13:10


PROCESSOR_SPECIFIC_DEVICE_INFO
VALIDATION_BITS 0x000000000110102f
PROC_ERROR_MAP 0x0000000201006000
Processor State Parameter 0xa8000000fff21330
[...]
[...]

GRs NaT bits 0x0000000000000000
PR (Predicates) 0x000000000000aa41
BR0 0xa000000100b07680
RSC 0x0000000000000003
IIP 0xa000000100b070f0
IPSR 0x00001010085a6010
IFS 0x800000000000050b
XIP 0xa000000100b070c0
XPSR 0x00001010085a6010
XFS 0x0000000000000000
BR1 0x0000000000000000

[...]

[...]


============ From System.map =================
For CPU0, the decoding the IIP and BR0:

IIP and BR0:

a000000100b06f60 t mdacon_setup
a000000100b07060 t mda_detect
a000000100b073a0 t mda_initialize
a000000100b075a0 t mdacon_startup
a000000100b077a0 T mda_console_init
a000000100b07840 T fbmem_init
a000000100b07ac0 T video_setup
a000000100b07d00 t neo_init
a000000100b07d40 T neofb_setup
a000000100b07fa0 T neofb_init
a000000100b08040 T tdfxfb_init


Thanks
Sourav




ELILO
Loading vmlinux...Loading Linux... ..done
Loading initrd root.bin.sys...done
Linux version 2.6.6-rc3 (souravs@erage1.india.hp.com) (gcc version 3.2.3
2003050
2 (Red Hat Linux 3.2.3-24)) #7 SMP Wed May 5 13:56:37 IST 2004
EFI v1.10 by HP: SALsystab=0x3ff88000 ACPI 2.0=0x3fdf8000 SMBIOS=0x3ff8a000
HCDP
=0x3fdf7000
booting generic kernel on platform hpzx1
ACPI: RSDP (v002 HP ) @
0x000000003fdf800
0
ACPI: XSDT (v001 HP rx2600 0x00000000 HP 0x00000000) @
0x000000003fdf802c
ACPI: FADT (v003 HP rx2600 0x00000000 HP 0x00000000) @
0x000000003fdfe3f0
ACPI: SPCR (v001 HP rx2600 0x00000000 HP 0x00000000) @
0x000000003fdfe528
ACPI: DBGP (v001 HP rx2600 0x00000000 HP 0x00000000) @
0x000000003fdfe578
ACPI: MADT (v001 HP rx2600 0x00000000 HP 0x00000000) @
0x000000003fdfe638
A SPMI (v004 HP rx2600 0x00000000 HP 0x00000000) @ 0x000000003fdfe5b0
ACPI: CPEP (v001 HP rx2600 0x00000000 HP 0x000) @ 0x000000003fdfe600
ACPI: SSDT (v001 HP rx2600 0x00000006 INTL 0x02012044) @
0x000000003fdfc68
0
ACPI: SSDT (v001 rx2600 0x00000006 INTL 0x02012044) @ 0x000000003fdfc740
ACPI: SSDT (v001 HP rx2600 0x00000006 INTL 0x02012044) @ 0x000000fc970
ACPI: SSDT (v001 HP rx2600 0x00000006 INTL 0x02012044) @
0x000000003fdfcfe
0
ACPI: SSDT (v001 HP rx2600 0x000 INTL 0x02012044) @ 0x000000003fdfd650
ACPI: SSDT (v001 HP rx2600 0x00000006 INTL 0x02012044) @
0x000000003fdfdcc
0
ACPI: (v001 HP rx2600 0x00000006 INTL 0x02012044) @ 0x000000003fdfe330
ACPI: DSDT (v001 HP rx2600 0x00000007 INTL 0x0201 @ 0x0000000000000000
Warning: acpi_table_parse(ACPI_SRAT) returned 0!
Warning: acpi_table_parse(ACPI_SLIT) returned 0!
efi.top: ignoring 4KB of memory at 0x0 due to granule hole at 0x0
efi.trim_top: ignoring 636KB of memory at 0x1000 due to granule ho 0x0
efi.trim_bottom: ignoring 15360KB of memory at 0x100000 due to granule hole
at 0
x0
Initial ramdisk at: 0xe00000407cf9f00054432 bytes)
SAL 0.20: INTEL MSL REF SAL version 1.60
SAL: AP wakeup using external interrupt vector 0xff
ACPIal APIC address 0xc0000000fee00000
ACPI: LAPIC_ADDR_OVR (address[00000000fee00000])
ACPI: LSAPIC (acpi_id[0x00] lsapic_id[0x00pic_eid[0x00] enabled)
CPU 0 (0x0000) enabled (BSP)
ACPI: LSAPIC (acpi_id[0x01] lsapic_id[0x01] lsapic_eid[0x00] enabled)
CPUx0100) enabled
ACPI: IOSAPIC (id[0x0] global_irq_base[0x10] address[00000000fed20800])
ACPI: IOSAPIC (id[0x1] global_irq_base[ address[00000000fed22800])
ACPI: IOSAPIC (id[0x2] global_irq_base[0x26] address[00000000fed24800])
ACPI: IOSAPIC (id[0x3] glorq_base[0x31] address[00000000fed26800])
ACPI: IOSAPIC (id[0x4] global_irq_base[0x3c] address[00000000fed28800])
ACPI: IOSAPIC0x6] global_irq_base[0x47] address[00000000fed2c800])
ACPI: IOSAPIC (id[0x7] global_irq_base[0x52] address[00000000fed2e800])
0x24(low,level) -> CPU 0x0000 vector 48
2 CPUs available, 2 CPUs total
GSI 0x52(high,edge) -> CPU 0x0000 vector 49
MCA relatetialization done
Virtual mem_map starts at 0xa0007fffbf800000
On node 0 totalpages: 126648
Normal zone: 0 pages, LIFO batch:1
HighMem zone: 0 pages, LIFO batch:1
Built 1 zonelists
Kernel command line: BOOT_IMAGE0:\vmlinux console=ttyS0 root=100
ramdisk_size=3
2768k
PID hash table entries: 4096 (order 12: 65536 bytes)
CPU 0: base freq=20MHz, ITC ratio=9/2, ITC freq=900.000MHz+/-450ppm
Console: colour VGA+ 80x25
Memory: 2013184k/2026368k available (9582k code, 28k reserved, 4147k data,
656k
init)
Leaving McKinley Errata 9 workaround enabled
Calibrating delay loop... 1347.52 BogoMIPS
try cache hash table entries: 262144 (order: 7, 2097152 bytes)
Inode-cache hash table entries: 131072 (order: 6, 1048576 bytes)unt-cache
hash t
able entries: 1024 (order: 0, 16384 bytes)
POSIX conformance testing by UNIFIX
Boot processor id 0x0/0x0
taskation cache decay timeout: 10 msecs.
CPU 1: base freq=200.000MHz, ITC ratio=9/2, ITC freq=900.000MHz+/-450ppm
Calibrating delay loop... 1347.52 BogoMIPS
CPU 1: synchronized ITC with CPU 0 (last diff -6 cycles, maxerr 434 cycles)
Brought up 2 CPUs
Total of 2 processors activated (2694.04 BogoMIPS).
NET: Registered protocol family 16
ACPI: Subsystem revision 20040326
ACPI: Interpreter enabled
ACPI: Using IOSAPIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (00:00)
ACPI: PCI Root Bridge [PCI1] (00:20)
ACPI: PCI Root Bridge [PCI2] (00:40)
ACPI: PCI Root Bridge [PCI3] (00:60)
ACPI: PCI Root Bridge [PCI4] (00:80)
ACPI: PCI Root Bridge [PCI6] (00:c0)
ACPI: PCI Root Bridge [PCI7] (00:e0)
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
register_intr: changing vector 49 from IO-SAPIC-edge to IO-SAPIC-level
IOSAPIC: vector 50 -> CPU 0x0000, enabled
IOSAPIC: vector 51 -> CPU 0x0100, enabled
IOSAPIC: vector 52 -> CPU 0x0000, enabled
IOSAPIC: vector 53 -> CPU 0x0100, enabled
IOSAPIC: vector 54 -> CPU 0x0000, enabled
IOSAPIC: vector 55 -> CPU 0x0100, enabled
IOSAPIC: vector 56 -> CPU 0x0000, enabled
IOSAPIC: vector 57 -> CPU 0x0100, enabled
IOSAPIC: vector 49 -> CPU 0x0000, enabled
IOSAPIC: vector 49 -> CPU 0x0100, enabled
IOSAPIC: vector 74 -> CPU 0x0000, enabled
PCI: Using ACPI for IRQ routing
IOC: zx1 2.2 HPA 0xfed01000 IOVA space 1024Mb at 0x40000000
NET: Registered protocol family 23
PAL Information Facility v0.5
ikconfig 0.7 with /proc/config*
Total HugeTLB memory allocated, 0
udf: registering filesystem
Initializing Cryptographic API
PI: Processor [CPU0] (supports C1)
ACPI: Processor [CPU1] (supports C1)

************* SYSTEM ALERT **************
SYSTEM NAME: lrage1g

05 May 2004 13:30:09
Alert Level 7: Fatal
Keyword: Type-02 137001 1273857
Machine Check initiated
Logged by: SFW-redundant; Sensor: Critical Interrupt
Data2: OEM Code2: 0x00
0xC14098EC61024000 003FA17000130300

A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:A
*****************************************

************* SYSTEM ALERT **************
SYSTEM NAME: lrage1g

05 May 2004 13:30:09
Alert Level 7: Fatal
Keyword: MC_INITIATED
Machine Check initiated
Logged by: System Firmware 0
Data: Implementation dependent data field
0xF680009800E05AA5 0000000000000000

A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:A
*****************************************

************* SYSTEM ALERT **************
SYSTEM NAME: lrage1g

05 May 2004 13:30:10
Alert Level 7: Fatal
Keyword: Type-02 137001 1273857
Machine Check initiated
Logged by: SFW-redundant; Sensor: Critical Interrupt
Data2: OEM Code2: 0x01
0xC14098EC62024000 013FA17000130300

A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:Timeout!
*****************************************

************* SYSTEM ALERT **************
SYSTEM NAME: lrage1g

05 May 2004 13:30:10
Alert Level 7: Fatal
Keyword: MC_INITIATED
Machine Check initiated
Logged by: System Firmware 1
Data: Implementation dependent data field
0xF680009801E05AA5 0000000000000001

A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 14:02    [W:0.045 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site