lkml.org 
[lkml]   [2003]   [May]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    Subjectusb [mouse] not working in mm4

    With the same config, in mm3, it works.
    boot log for mm4 attached.Linux version 2.5.68-mm4 (root@hate) (gcc version 3.2.2 20030322 (Gentoo Linux 1.4 3.2.2-r2)) #1 Sat May 3 15:33:50 EEST 2003
    Video mode to be used for restore is ffff
    BIOS-provided physical RAM map:
    BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
    BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
    BIOS-e820: 0000000000100000 - 000000001fff0000 (usable)
    BIOS-e820: 000000001fff0000 - 000000001fff3000 (ACPI NVS)
    BIOS-e820: 000000001fff3000 - 0000000020000000 (ACPI data)
    BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
    511MB LOWMEM available.
    On node 0 totalpages: 131056
    DMA zone: 4096 pages, LIFO batch:1
    Normal zone: 126960 pages, LIFO batch:16
    HighMem zone: 0 pages, LIFO batch:1
    ACPI: RSDP (v000 VIA694 ) @ 0x000f6f40
    ACPI: RSDT (v001 VIA694 AWRDACPI 16944.11825) @ 0x1fff3000
    ACPI: FADT (v001 VIA694 AWRDACPI 16944.11825) @ 0x1fff3040
    ACPI: DSDT (v001 VIA694 AWRDACPI 00000.04096) @ 0x00000000
    ACPI: BIOS passes blacklist
    ACPI: MADT not present
    Building zonelist for node : 0
    Kernel command line:
    Local APIC disabled by BIOS -- reenabling.
    Found and enabled local APIC!
    Initializing CPU#0
    PID hash table entries: 2048 (order 11: 16384 bytes)
    Detected 900.463 MHz processor.
    Console: colour VGA+ 80x25
    Calibrating delay loop... 1769.47 BogoMIPS
    Memory: 515088k/524224k available (2050k kernel code, 8392k reserved, 628k data, 308k init, 0k highmem)
    Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
    Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
    Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
    -> /dev
    -> /dev/console
    -> /root
    CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
    CPU: L2 Cache: 256K (64 bytes/line)
    CPU: After generic, caps: 0183fbff c1c7fbff 00000000 00000020
    Intel machine check architecture supported.
    Intel machine check reporting enabled on CPU#0.
    CPU: AMD Athlon(tm) Processor stepping 02
    Enabling fast FPU save and restore... done.
    Checking 'hlt' instruction... OK.
    POSIX conformance testing by UNIFIX
    enabled ExtINT on CPU#0
    ESR value before enabling vector: 00000000
    ESR value after enabling vector: 00000000
    Using local APIC timer interrupts.
    calibrating APIC timer ...
    ..... CPU clock speed is 899.0807 MHz.
    ..... host bus clock speed is 199.0957 MHz.
    mtrr: v2.0 (20020519)
    PCI: PCI BIOS revision 2.10 entry at 0xfb4d0, last bus=1
    PCI: Using configuration type 1
    BIO: pool of 256 setup, 14Kb (56 bytes/bio)
    biovec pool[0]: 1 bvecs: 256 entries (12 bytes)
    biovec pool[1]: 4 bvecs: 256 entries (48 bytes)
    biovec pool[2]: 16 bvecs: 256 entries (192 bytes)
    biovec pool[3]: 64 bvecs: 256 entries (768 bytes)
    biovec pool[4]: 128 bvecs: 256 entries (1536 bytes)
    biovec pool[5]: 256 bvecs: 256 entries (3072 bytes)
    ACPI: Subsystem revision 20030418
    spurious 8259A interrupt: IRQ7.
    ACPI: Interpreter enabled
    ACPI: Using PIC for interrupt routing
    ACPI: PCI Root Bridge [PCI0] (00:00)
    PCI: Probing PCI hardware (bus 00)
    Disabling VIA memory write queue (PCI ID 0305, rev 03): [55] 8d & 1f -> 0d
    ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
    ACPI: PCI Interrupt Link [LNKA] (IRQs 1 3 4 5 6 7 10 11 12 14 15, disabled)
    ACPI: PCI Interrupt Link [LNKB] (IRQs 1 3 4 5 6 7 10 11 12 14 15, disabled)
    ACPI: PCI Interrupt Link [LNKC] (IRQs 1 3 4 5 6 7 *10 11 12 14 15)
    ACPI: PCI Interrupt Link [LNKD] (IRQs 1 3 4 5 6 7 10 *11 12 14 15)
    block request queues:
    4/1024 requests per read queue
    4/1024 requests per write queue
    enter congestion at 127
    exit congestion at 129
    drivers/usb/core/usb.c: registered new driver usbfs
    drivers/usb/core/usb.c: registered new driver hub
    ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 5
    ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11
    PCI: Using ACPI for IRQ routing
    PCI: if you experience problems, try using option 'pci=noacpi' or even 'acpi=off'
    Initializing RT netlink socket
    Machine check exception polling timer started.
    Enabling SEP on CPU 0
    VFS: Disk quotas dquot_6.5.1
    Journalled Block Device driver loaded
    devfs: v1.22 (20021013) Richard Gooch (rgooch@atnf.csiro.au)
    devfs: boot_options: 0x1
    NTFS driver 2.1.4 [Flags: R/O].
    Initializing Cryptographic API
    Applying VIA southbridge workaround.
    ACPI: Power Button (FF) [PWRF]
    ACPI: Processor [CPU0] (supports C1 C2, 2 throttling states)
    pty: 256 Unix98 ptys configured
    Real Time Clock Driver v1.11
    Linux agpgart interface v0.100 (c) Dave Jones
    agpgart: Detected VIA Apollo Pro KT133/KM133/TwisterK chipset
    agpgart: Maximum main memory to use for agp memory: 439M
    agpgart: AGP aperture is 64M @ 0xe0000000
    Hangcheck: starting hangcheck timer 0.5.0 (tick is 180 seconds, margin is 60 seconds).
    Serial: 8250/16550 driver $Revision: 1.90 $ IRQ sharing disabled
    anticipatory scheduling elevator
    Floppy drive(s): fd0 is 1.44M
    FDC 0 is a post-1991 82077
    8139too Fast Ethernet driver 0.9.26
    eth0: RealTek RTL8139 Fast Ethernet at 0xe0829000, 00:02:44:16:e4:1e, IRQ 11
    eth0: Identified 8139 chip type 'RTL-8139C'
    Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
    ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
    VP_IDE: IDE controller at PCI slot 00:07.1
    VP_IDE: chipset revision 6
    VP_IDE: not 100% native mode: will probe irqs later
    ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
    VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
    ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:DMA, hdd:pio
    hda: QUANTUM FIREBALLP AS40.0, ATA DISK drive
    anticipatory scheduling elevator
    ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
    hdc: CD-540E, ATAPI CD/DVD-ROM drive
    anticipatory scheduling elevator
    ide1 at 0x170-0x177,0x376 on irq 15
    hda: host protected area => 1
    hda: 78177792 sectors (40027 MB) w/1902KiB Cache, CHS=77557/16/63, UDMA(100)
    /dev/ide/host0/bus0/target0/lun0: p1 p2 p3
    hdc: ATAPI 40X CD-ROM drive, 128kB Cache, UDMA(33)
    Uniform CD-ROM driver Revision: 3.12
    end_request: I/O error, dev hdc, sector 0
    drivers/usb/host/uhci-hcd.c: USB Universal Host Controller Interface driver v2.0
    uhci-hcd 00:07.2: VIA Technologies, In USB
    uhci-hcd 00:07.2: irq 11, io base 0000d400
    Please use the 'usbfs' filetype instead, the 'usbdevfs' name is deprecated.
    uhci-hcd 00:07.2: new USB bus registered, assigned bus number 1
    hub 1-0:0: USB hub found
    hub 1-0:0: 2 ports detected
    drivers/usb/core/usb.c: registered new driver hid
    drivers/usb/input/hid-core.c: v2.0:USB HID core driver
    mice: PS/2 mouse device common for all mice
    Trying to free free IRQ12
    Trying to free free IRQ12
    Trying to free free IRQ12
    Trying to free free IRQ12
    serio: i8042 AUX port at 0x60,0x64 irq 12
    input: AT Set 2 keyboard on isa0060/serio0
    serio: i8042 KBD port at 0x60,0x64 irq 1
    Advanced Linux Sound Architecture Driver Version 0.9.2 (Thu Mar 20 13:31:57 2003 UTC).
    request_module: failed /sbin/modprobe -- snd-card-0. error = -16
    PCI: Setting latency timer of device 00:07.5 to 64
    hub 1-0:0: debounce: port 2: delay 100ms stable 4 status 0x301
    hub 1-0:0: new USB device on port 2, assigned address 2
    ALSA device list:
    #0: VIA 82C686A/B rev50 at 0xdc00, irq 10
    NET4: Linux TCP/IP 1.0 for NET4.0
    IP: routing cache hash table of 4096 buckets, 32Kbytes
    TCP: Hash tables configured (established 32768 bind 65536)
    NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
    kjournald starting. Commit interval 5 seconds
    EXT3-fs: mounted filesystem with ordered data mode.
    VFS: Mounted root (ext3 filesystem) readonly.
    Mounted devfs on /dev
    Freeing unused kernel memory: 308k freed
    usb 1-2: USB device not accepting new address=2 (error=-110)
    hub 1-0:0: new USB device on port 2, assigned address 3
    usb 1-2: USB device not accepting new address=3 (error=-110)
    EXT3 FS 2.4-0.9.16, 02 Dec 2001 on ide/host0/bus0/target0/lun0/par, internal journal
    NTFS volume version 3.1.
    NTFS volume version 3.1.
    Adding 262136k swap on /swap. Priority:-1 extents:786
    eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 41e1.
    \
     
     \ /
      Last update: 2005-03-22 13:35    [W:0.031 / U:152.680 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site