[lkml]   [2003]   [Apr]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    Subject2.4.21pre6 (__ide_dma_test_irq) called while not waiting
    I have a hpt370 based controller which shares an irq with a broadcom
    bcm4401 network adaptor.

    when transferring stuff over the network the ide controller drops the
    dma for all disks on the controller repeatedly... so it is not a
    cable/disk problem but a problem in the nic's driver/the hpt driver.

    however this stuff only happens when I put high load on the nic. the
    drives form a software raid and reconstructing it does not cause any

    here is my setup:
    7: 28328328 XT-PIC ide4, ide5, eth0

    hdi: 4 bytes in FIFO
    hdi: timeout waiting for DMA
    hdi: (__ide_dma_test_irq) called while not waiting
    hdi: dma_intr: status=0x58 { DriveReady SeekComplete DataRequest }

    hdk: dma_intr: status=0x58 { DriveReady SeekComplete DataRequest }

    hdk: status timeout: status=0xd0 { Busy }

    hdk: DMA disabled
    hdk: drive not ready for command
    ide4: reset: success
    ide5: reset: success


    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    More majordomo info at
    Please read the FAQ at

     \ /
      Last update: 2005-03-22 13:34    [W:0.030 / U:22.568 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site