Messages in this thread | | | From | Michael Frank <> | Subject | Re: 2.4.21-pre7, 2.5.66, IDE Errors during boot - just a nuisance ? | Date | Fri, 11 Apr 2003 15:55:21 +0800 |
| |
I just brought it up because 2.4.21 is on its way and i'am not used to error messages - even "small" ones -, which werent there before being ignored.
Best Regards Michael
On Friday 11 April 2003 15:39, Jarmo Järvenpää wrote: > Indeed we have the same problem. > > This gives a bit of headache, hda1 and hdc1 are software raid 1 array > and sometimes one disk is dropped from the array due "error" on the > disk. > Hotadd will succeed and no bad blocks on either disk. No problems with > 2.4.18. Not tested with .19 nor .20. > > > BR, > Jarmo > > > Kernel 2.4.2.21-pre6 > > lspci: > 00:00.0 Host bridge: Intel Corp. 440LX/EX - 82443LX/EX Host bridge (rev > 03) > 00:01.0 PCI bridge: Intel Corp. 440LX/EX - 82443LX/EX AGP bridge (rev > 03) > 00:07.0 ISA bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 01) > 00:07.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01) > 00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01) > 00:07.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 01) > 00:0e.0 VGA compatible controller: Matrox Graphics, Inc. MGA 2164W > [Millennium II] > 00:10.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone] > (rev 30) > > > dmesg: > ide: Assuming 33MHz system bus speed for PIO modes; override with > idebus=xx > PIIX4: IDE controller at PCI slot 00:07.1 > PIIX4: chipset revision 1 > PIIX4: not 100% native mode: will probe irqs later > ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:pio > ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:pio > hda: QUANTUM FIREBALL_TM3200A, ATA DISK drive > hdb: E295X, ATAPI CD/DVD-ROM drive > blk: queue c02e1ee0, I/O limit 4095Mb (mask 0xffffffff) > hdc: QUANTUM FIREBALL_TM3200A, ATA DISK drive > blk: queue c02e2330, I/O limit 4095Mb (mask 0xffffffff) > ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > ide1 at 0x170-0x177,0x376 on irq 15 > hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error } > hda: task_no_data_intr: error=0x04 { DriveStatusError } > hda: 6281856 sectors (3216 MB) w/76KiB Cache, CHS=779/128/63, DMA > hdc: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error } > hdc: task_no_data_intr: error=0x04 { DriveStatusError } > hdc: 6281856 sectors (3216 MB) w/76KiB Cache, CHS=6232/16/63, DMA > hdb: ATAPI 16X CD-ROM drive, 240kB Cache, DMA > Uniform CD-ROM driver Revision: 3.12 > Partition check: > > > cat /proc/ide/piix > Controller: 0 > > Intel PIIX4 Ultra 33 Chipset. > --------------- Primary Channel ---------------- Secondary Channel > ------------- > enabled enabled > --------------- drive0 --------- drive1 -------- drive0 ---------- > drive1 ------ > DMA enabled: yes yes yes no > UDMA enabled: no no no no > UDMA enabled: X X X X > UDMA > DMA > PIO > > > hdparm -I /dev/hda > /dev/hda: > > ATA device, with non-removable media > Model Number: QUANTUM FIREBALL_TM3200A > Serial Number: 295702034106 > Firmware Revision: A6B.2400 > Standards: > Likely used: 2 > Configuration: > Logical max current > cylinders 6232 6232 > heads 16 16 > sectors/track 63 63 > -- > bytes/track: 32256 bytes/sector: 512 > CHS current addressable sectors: 6281856 > LBA user addressable sectors: 6281856 > device size with M = 1024*1024: 3067 MBytes > device size with M = 1000*1000: 3216 MBytes (3 GB) > Capabilities: > LBA, IORDY(can be disabled) > Buffer size: 76.5kB bytes avail on r/w long: 4 > Standby timer values: spec'd by Vendor > R/W multiple sector transfer: Max = 16 Current = 16 > DMA: sdma0 sdma1 sdma2 mdma0 mdma1 *mdma2 > Cycle time: min=120ns recommended=120ns > PIO: pio0 pio1 pio2 pio3 pio4 > Cycle time: no flow control=300ns IORDY flow control=120ns > > hdparm -I /dev/hdc > /dev/hdc: > > ATA device, with non-removable media > Model Number: QUANTUM FIREBALL_TM3200A > Serial Number: 295634511413 > Firmware Revision: A6B.2400 > Standards: > Likely used: 2 > Configuration: > Logical max current > cylinders 6232 6232 > heads 16 16 > sectors/track 63 63 > -- > bytes/track: 32256 bytes/sector: 512 > CHS current addressable sectors: 6281856 > LBA user addressable sectors: 6281856 > device size with M = 1024*1024: 3067 MBytes > device size with M = 1000*1000: 3216 MBytes (3 GB) > Capabilities: > LBA, IORDY(can be disabled) > Buffer size: 76.5kB bytes avail on r/w long: 4 > Standby timer values: spec'd by Vendor > R/W multiple sector transfer: Max = 16 Current = 16 > DMA: sdma0 sdma1 sdma2 mdma0 mdma1 *mdma2 > Cycle time: min=120ns recommended=120ns > PIO: pio0 pio1 pio2 pio3 pio4 > Cycle time: no flow control=300ns IORDY flow control=120ns > > Michael Frank wrote: > > Noticed this for some time in 2.5.64 and up, and now also in 2.4.21-pre6 > > and pre7. It was OK 2.4.20. No functional problems were encountered with > > 2.4.21, 2.5.6x so far. > > > > Its a P1, lspci follows > > > > 00:00.0 Host bridge: Intel Corp. 430HX - 82439HX TXC [Triton II] (rev 03) > > 00:07.0 ISA bridge: Intel Corp. 82371SB PIIX3 ISA [Natoma/Triton II] (rev > > 01) 00:07.1 IDE interface: Intel Corp. 82371SB PIIX3 IDE [Natoma/Triton > > II] 00:09.0 VGA compatible controller: S3 Inc. ViRGE/DX or /GX (rev 01) > > 00:0a.0 Ethernet controller: Realtek Semiconductor Co., Ltd. > > RTL-8139/8139C/8139C+ (rev 10) 00:0b.0 SCSI storage controller: Adaptec > > AHA-7850 (rev 01) > > > > Apr 10 15:17:30 mhfl1 kernel: Linux version 2.4.21-pre7-mhf18-np > > (mhf@mhfl3) (gcc version 2.95.3 20010315 (release)) #2 > > > > Apr 10 15:12:42 mhfl1 kernel: Uniform Multi-Platform E-IDE driver > > Revision: 7.00beta-2.4 Apr 10 15:12:42 mhfl1 kernel: ide: Assuming 33MHz > > system bus speed for PIO modes; override with idebus=xx Apr 10 15:12:42 > > mhfl1 kernel: PIIX3: IDE controller at PCI slot 00:07.1 Apr 10 15:12:42 > > mhfl1 kernel: PIIX3: chipset revision 0 > > Apr 10 15:12:42 mhfl1 kernel: PIIX3: not 100%% native mode: will probe > > irqs later Apr 10 15:12:42 mhfl1 kernel: ide0: BM-DMA at > > 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio Apr 10 15:12:42 mhfl1 > > kernel: ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, > > hdd:pio Apr 10 15:12:42 mhfl1 kernel: hda: QUANTUM BIGFOOT2550A, ATA DISK > > drive Apr 10 15:12:42 mhfl1 kernel: blk: queue c0347ae0, I/O limit 4095Mb > > (mask 0xffffffff) Apr 10 15:12:42 mhfl1 kernel: ide0 at 0x1f0-0x1f7,0x3f6 > > on irq 14 Apr 10 15:12:43 mhfl1 kernel: hda: attached ide-disk driver. > > > > ------------------------------\/ > > Apr 10 15:12:43 mhfl1 kernel: hda: task_no_data_intr: status=0x53 { > > DriveReady SeekComplete Index Error } Apr 10 15:12:43 mhfl1 kernel: hda: > > task_no_data_intr: error=0x04 { DriveStatusError } > > > > Apr 10 15:12:43 mhfl1 kernel: hda: 5033952 sectors (2577 MB) w/87KiB > > Cache, CHS=624/128/63, DMA Apr 10 15:12:43 mhfl1 kernel: Partition check: > > Apr 10 15:12:43 mhfl1 kernel: hda: hda1 hda2 hda3 > > > > ---------- > > Mar 30 15:46:51 mhfl1 kernel: Linux version 2.5.66-mhf2 (mhf@mhfl2) (gcc > > version 2.95.3 20010315 (release)) #12 Sat Mar 29 > > > > Mar 30 15:47:05 mhfl1 kernel: Uniform Multi-Platform E-IDE driver > > Revision: 7.00alpha2 Mar 30 15:47:05 mhfl1 kernel: ide: Assuming 33MHz > > system bus speed for PIO modes; override with idebus=xx Mar 30 15:47:05 > > mhfl1 kernel: PIIX3: IDE controller at PCI slot 00:07.1 Mar 30 15:47:05 > > mhfl1 kernel: PIIX3: chipset revision 0 > > Mar 30 15:47:05 mhfl1 kernel: PIIX3: not 100%% native mode: will probe > > irqs later Mar 30 15:47:05 mhfl1 kernel: ide0: BM-DMA at > > 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio Mar 30 15:47:05 mhfl1 > > kernel: ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, > > hdd:pio Mar 30 15:47:05 mhfl1 kernel: hda: QUANTUM BIGFOOT2550A, ATA DISK > > drive Mar 30 15:47:05 mhfl1 kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > > > > ------------------------------\/ > > Mar 30 15:47:05 mhfl1 kernel: hda: task_no_data_intr: status=0x51 { > > DriveReady SeekComplete Error } Mar 30 15:47:05 mhfl1 kernel: hda: > > task_no_data_intr: error=0x04 { DriveStatusError } > > > > Mar 30 15:47:05 mhfl1 kernel: hda: 5033952 sectors (2577 MB) w/87KiB > > Cache, CHS=4994/16/63, DMA Mar 30 15:47:05 mhfl1 kernel: hda: hda1 hda2 > > hda3 > > > > Regards > > Michael > > > > - > > To unsubscribe from this list: send the line "unsubscribe linux-kernel" > > in the body of a message to majordomo@vger.kernel.org > > More majordomo info at http://vger.kernel.org/majordomo-info.html > > Please read the FAQ at http://www.tux.org/lkml/
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |