Messages in this thread | | | From | Duncan Sands <> | Subject | Re: 2.5 BK boot hang after ide | Date | Mon, 24 Mar 2003 10:38:11 +0100 |
| |
> > Copied down by hand: > > > > ... > > ide: Assuming 33MHz system bus speed for PIO modes; override with > > idebus=xx VP_IDE: IDE controller at PCI slot 00:11.1 > > ACPI: No IRQ known for interrupt pin A of device 00:11.1 - using IRQ 255 > > VP_IDE: Chipset revision 6 > > VP_IDE: not 100% native mode: will probe irqs later > > ide: Assuming 33MHz system bus speed for PIO modes; override with > > idebus=xx VP_IDE: VIA vt 8235 (rev 00) IDE UDMA 133 controller on > > pci00:11.1 ide0: BM_DMA at 0xfc00-0xfc07, BIOS settings: hda: DMA, hdb: > > DMA ide1: BM_DMA at 0xfc08-0xfc0f, BIOS settings: hdc: DMA, hdd: DMA hda: > > ST320423A, ATA DISK drive > > hdb: Maxtor 6E030L0, ATA DISK drive > > id0 at 0x1f0-0x1f7, 0x3f6 on irq 14 > > hdc: TOSHIBA DVD-ROM SD-MI402, ATAPI CD/DVD-ROM drive > > hdd: LG CD-RW CED-8080B, ATAPI CD/DVD-ROM drive > > ide1 at 0x170-0x177, 0x376 on irq 15 > > hda: host protected area => 1 > > hda : 40011300 sectors (20486 MB) w/512KiB Cache, CHS=39693/16/63, > > UDMA(66) hda: hda1 hda2 hda3 > > hdb: host protected area => 1 > > hdb : 60058656 sectors (30750 MB) w/2048KiB Cache, CHS=59582/16/63, > > UDMA(133) hdb: hdb1 > > (hangs) > > I'm experiencing exactly the same as you: 2.5 won't > continue past IDE. I've tried 2.5.65-ac3, 2.5.65-bk3 > and 2.5.65-mm4. All of them fail at the same point. > I've tried using ACPI, APM, disabling preempt, TCQ, > enabling SysRq support, but had no luck. > > The machine is a Pentium 4 2.0Gz, with a QDI > PlatiniX 2D/533-A (i845E), 2 UDMA100 disks > (Seagate ST380021A 80GB and IBM-DTLA-307030 > 20GB), a Pioneer DVD-ROM and Sony CRX185E3).
Seems to be OK with current BK.
Thanks,
Duncan. - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |