lkml.org 
[lkml]   [2003]   [Jan]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
SubjectRE: [2.5 patch] small cleanups for arch/cris/drivers/serial.c
Date
We have already done this locally but has not yet been able to 
get Linus to apply a patch to update CRIS architecture to 2.5
status.

I suggest that Linus does not apply this patch and instead
applies our patch that will get CRIS up to date with 2.5.55
(will be sent to Linus within the next hour).

Thanks for caring about our architecture!

/Mikael

-----Original Message-----
From: linux-kernel-owner@vger.kernel.org
[mailto:linux-kernel-owner@vger.kernel.org]On Behalf Of Adrian Bunk
Sent: Thursday, January 09, 2003 3:57 PM
To: Bjorn Wesen; dev-etrax
Cc: linux-kernel@vger.kernel.org
Subject: [2.5 patch] small cleanups for arch/cris/drivers/serial.c


The patch below makes the following changes to
arch/cris/drivers/serial.c:
- remove #if'd kernel 2.0 and 2.2 compatibility code
- remove an unused #define MIN

cu
Adrian


--- linux-2.5.55/arch/cris/drivers/serial.c.old 2003-01-09 15:42:43.000000000 +0100
+++ linux-2.5.55/arch/cris/drivers/serial.c 2003-01-09 15:53:52.000000000 +0100
@@ -301,12 +301,8 @@
#include <linux/fcntl.h>
#include <linux/mm.h>
#include <linux/slab.h>
-#if (LINUX_VERSION_CODE >= 131343)
#include <linux/init.h>
-#endif
-#if (LINUX_VERSION_CODE >= 131336)
#include <asm/uaccess.h>
-#endif
#include <linux/kernel.h>

#include <asm/io.h>
@@ -323,14 +319,6 @@
/* while we keep our own stuff (struct e100_serial) in a local .h file */
#include "serial.h"

-/*
- * All of the compatibilty code so we can compile serial.c against
- * older kernels is hidden in serial_compat.h
- */
-#if defined(LOCAL_HEADERS) || (LINUX_VERSION_CODE < 0x020317) /* 2.3.23 */
-#include "serial_compat.h"
-#endif
-
#define _INLINE_ inline

static DECLARE_TASK_QUEUE(tq_serial);
@@ -639,10 +627,6 @@
#define E100_DSR_GET(info) ((*e100_modem_pins[(info)->line].port) & (1 << e100_modem_pins[(info)->line].dsr_bit))


-#ifndef MIN
-#define MIN(a,b) ((a) < (b) ? (a) : (b))
-#endif
-
/*
* tmp_buf is used as a temporary buffer by serial_write. We need to
* lock it in case the memcpy_fromfs blocks while swapping in a page,
@@ -1648,12 +1632,8 @@

restore_flags(flags);

-#if LINUX_VERSION_CODE > KERNEL_VERSION(2,1,66)
/* this includes a check for low-latency */
tty_flip_buffer_push(tty);
-#else
- queue_task_irq_off(&tty->flip.tqueue, &tq_timer);
-#endif

/* unthrottle if we have throttled */
if (E100_RTS_GET(info) &&
@@ -2600,9 +2580,7 @@
info->type = new_serial.type;
info->close_delay = new_serial.close_delay;
info->closing_wait = new_serial.closing_wait;
-#if (LINUX_VERSION_CODE > 0x20100)
info->tty->low_latency = (info->flags & ASYNC_LOW_LATENCY) ? 1 : 0;
-#endif

check_and_exit:
if (info->flags & ASYNC_INITIALIZED) {
@@ -2775,41 +2753,6 @@
/*
* This routine sends a break character out the serial port.
*/
-#if (LINUX_VERSION_CODE < 131394) /* Linux 2.1.66 */
-static void
-send_break(struct e100_serial * info, int duration)
-{
- unsigned long flags;
-
- if (!info->port)
- return;
-
- current->state = TASK_INTERRUPTIBLE;
- current->timeout = jiffies + duration;
-
- save_flags(flags);
- cli();
-
- /* Go to manual mode and set the txd pin to 0 */
-
- info->tx_ctrl &= 0x3F; /* Clear bit 7 (txd) and 6 (tr_enable) */
- info->port[REG_TR_CTRL] = info->tx_ctrl;
-
- /* wait for "duration" jiffies */
-
- schedule();
-
- info->tx_ctrl |= (0x80 | 0x40); /* Set bit 7 (txd) and 6 (tr_enable) */
- info->port[REG_TR_CTRL] = info->tx_ctrl;
-
- /* the DMA gets awfully confused if we toggle the tranceiver like this
- * so we need to reset it
- */
- *info->ocmdadr = 4;
-
- restore_flags(flags);
-}
-#else
static void
rs_break(struct tty_struct *tty, int break_state)
{
@@ -2830,19 +2773,15 @@
info->port[REG_TR_CTRL] = info->tx_ctrl;
restore_flags(flags);
}
-#endif

static int
rs_ioctl(struct tty_struct *tty, struct file * file,
unsigned int cmd, unsigned long arg)
{
struct e100_serial * info = (struct e100_serial *)tty->driver_data;
-#if defined(CONFIG_ETRAX_RS485) || (LINUX_VERSION_CODE < 131394) /* Linux 2.1.66 */
+#if defined(CONFIG_ETRAX_RS485)
int error;
#endif
-#if (LINUX_VERSION_CODE < 131394) /* Linux 2.1.66 */
- int retval;
-#endif

if ((cmd != TIOCGSERIAL) && (cmd != TIOCSSERIAL) &&
(cmd != TIOCSERCONFIG) && (cmd != TIOCSERGWILD) &&
@@ -2852,45 +2791,6 @@
}

switch (cmd) {
-#if (LINUX_VERSION_CODE < 131394) /* Linux 2.1.66 */
- case TCSBRK: /* SVID version: non-zero arg --> no break */
- retval = tty_check_change(tty);
- if (retval)
- return retval;
- tty_wait_until_sent(tty, 0);
- if (signal_pending(current))
- return -EINTR;
- if (!arg) {
- send_break(info, HZ/4); /* 1/4 second */
- if (signal_pending(current))
- return -EINTR;
- }
- return 0;
- case TCSBRKP: /* support for POSIX tcsendbreak() */
- retval = tty_check_change(tty);
- if (retval)
- return retval;
- tty_wait_until_sent(tty, 0);
- if (signal_pending(current))
- return -EINTR;
- send_break(info, arg ? arg*(HZ/10) : HZ/4);
- if (signal_pending(current))
- return -EINTR;
- return 0;
- case TIOCGSOFTCAR:
- error = verify_area(VERIFY_WRITE, (void *) arg,sizeof(long));
- if (error)
- return error;
- put_fs_long(C_CLOCAL(tty) ? 1 : 0,
- (unsigned long *) arg);
- return 0;
- case TIOCSSOFTCAR:
- arg = get_fs_long((unsigned long *) arg);
- tty->termios->c_cflag =
- ((tty->termios->c_cflag & ~CLOCAL) |
- (arg ? CLOCAL : 0));
- return 0;
-#endif
case TIOCMGET:
return get_modem_info(info, (unsigned int *) arg);
case TIOCMBIS:
@@ -3311,9 +3211,7 @@
tty->driver_data = info;
info->tty = tty;

-#if (LINUX_VERSION_CODE > 0x20100)
info->tty->low_latency = (info->flags & ASYNC_LOW_LATENCY) ? 1 : 0;
-#endif

if (!tmp_buf) {
page = get_zeroed_page(GFP_KERNEL);
@@ -3497,9 +3395,7 @@

memset(&serial_driver, 0, sizeof(struct tty_driver));
serial_driver.magic = TTY_DRIVER_MAGIC;
-#if (LINUX_VERSION_CODE > 0x20100)
serial_driver.driver_name = "serial";
-#endif
serial_driver.name = "ttyS";
serial_driver.major = TTY_MAJOR;
serial_driver.minor_start = 64;
@@ -3530,14 +3426,10 @@
serial_driver.stop = rs_stop;
serial_driver.start = rs_start;
serial_driver.hangup = rs_hangup;
-#if (LINUX_VERSION_CODE >= 131394) /* Linux 2.1.66 */
serial_driver.break_ctl = rs_break;
-#endif
-#if (LINUX_VERSION_CODE >= 131343)
serial_driver.send_xchar = rs_send_xchar;
serial_driver.wait_until_sent = rs_wait_until_sent;
serial_driver.read_proc = rs_read_proc;
-#endif

/*
* The callout device is just like normal device except for
@@ -3547,10 +3439,8 @@
callout_driver.name = "cua";
callout_driver.major = TTYAUX_MAJOR;
callout_driver.subtype = SERIAL_TYPE_CALLOUT;
-#if (LINUX_VERSION_CODE >= 131343)
callout_driver.read_proc = 0;
callout_driver.proc_entry = 0;
-#endif

if (tty_register_driver(&serial_driver))
panic("Couldn't register serial driver\n");
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
\
 
 \ /
  Last update: 2005-03-22 13:32    [W:0.051 / U:0.196 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site