Messages in this thread |  | | Date | Tue, 14 Jan 2003 04:10:19 -0700 (MST) | From | kosh@aesaeion ... | Subject | usb-uhci host controller halted 2.5.56 |
| |
I am getting this error
drivers/usb/host/uhci-hcd.c: dc00: host controller process error. something bad happened drivers/usb/host/uhci-hcd.c: dc00: host controller halted. very bad usb 1-1: USB disconnect, address 2 hub 1-0:0: debounce: port 1: delay 100ms stable 4 status 0x301 hub 1-0:0: new USB device on port 1, assigned address 3 input: USB HID v1.10 Mouse [Logitech USB Mouse] on usb-00:0d.0-1
What happens is that the mouse just turns off but it will work again if I unplug it and plug it back in again. When I first start up 2.5.56 it will often work for a few hours up to about 16 hours before usb will just start having those error messages. However once that happens and I unplug the mouse and plug it back in again the problem will happen every minute or so.
It is a VIA kt333 chipset with a usb mouseman wheel logitech optical mouse
This issue does not happen under any 2.4.x kernel.
Also this board has both an UHCI and an EHCI controller and if I compile support for the EHCI and UHCI controllers into a 2.5 series kernel when the host controller halts like that unplugging the mouse and plugging it back in again does not work. Under a 2.4 kernel both UHCI and EHCI controllers can be enabled and working without these problems.
Thanks
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
|  |