Messages in this thread | | | Date | Mon, 30 Sep 2002 16:47:57 +0100 | From | Andrew Walrond <> | Subject | Re: IDE Problems with 2.5.39 |
| |
Nope; This is the latest Asus PR-DLS dual Xeon motherboard with
ServerWorks^® Grand Champion LE North Bridge (CMIC-LE) ServerWorks^® Champion South Bridge (CSB5) ServerWorks^® 64-bit PCI-X Bridge (CIOB-X2)
And the Serverworks IDE driver doesn't see my drive. Works Fine with 2.4.20-pre8
Who should I be talking to?
JF wrote:
>On Sun, 2002-09-29 at 23:50, Andrew Walrond wrote: > > >>Hi, >> >>I can't boot with 2.5.39 because the built-in ide driver (ServerWorks >>CSB5) can't see hda, and VFS says "Cannot open root device "hda3" or >>03:03" which results in a kernel panic >> >>Works fine with 2.4.20-pre? with identical kernel setup and kernel >>parameter root=/dev/hda3 >> >>Is this a known problem? Any way around it or patches? >> >> > >I used to have this problem with 2.5 too >It went from the IDE controller chipset. > >Are you sure that you have only 1 IDE controller chipset ? > >I have both PIIX4 and HPT366. Root FS is on HPT366 controller. Enabling >only PIIX4 used to work with 2.4 but doesn't with 2.5 anymore (got >exactly your problem). I had to enable specific support for both. > >I suppose your root FS is on a specific IDE controller for which the >support is not enabled (check the different type in the IDE/ATA kernel >config section) > >Regards. > > >
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |