Messages in this thread |  | | Date | Sat, 24 Aug 2002 14:52:59 +0200 | From | Jean-Luc Coulon <> | Subject | Re: 2.4.20-pre2-ac3 stops responding |
| |
Alan Cox wrote: > > "On Fri, 2002-08-16 at 18:13, Jean-Luc Coulon wrote: > > At boot time, I get the messages : > > > > Aug 16 11:34:19 f5ibh kernel: ALI15X3: simplex device: DMA disabled > > Aug 16 11:34:19 f5ibh kernel: ide0: ALI15X3 Bus-Master DMA disabled > > (BIOS) > > Linux did the simplex device check. Your ALi controller only permits DMA > on one of the devices at a time. What is attached to the ALi controller > ? Also does 2.4.19 base enable DMA correctly ? > > If so then my guess is there is a bug in the changing of the pci setup > code in 2.4.20pre2-ac3, which shouldnt be hard to figure out
sorry for the late answer, I was not @home for one week.
Attached to my ide ports are : on the primary channel : 1 ide disk, QUANTUM FIREBALLP LM30 1 ide disk, ST3491A
on the secondary channel : 1 cdrom reader, CREATIVECD3621E 1 cdrom burner, GoldStar CD-RW CED-8083B
The second HDD is not DMA
------- regards Jean-Luc - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
|  |