[lkml]   [2002]   [Aug]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: Linux 2.4.20-pre4-ac1
> All the pre2-acX and pre4-ac1 run as fine when all are IDE, but the SCSI
> option causes a hang immediately after swap is enabled - the next item is
> normally "Setting hard drive parameters for hda:", but you never see that.

Im still chasing a couple ide-scsi problems.

> The message "Warning: Primary channel requires an 80-pin cable for operation"
> is (apart from being wrongly asserted as we know) incorrect is detail:
> the plugs ARE 40-pin, the cable however is 80 conductor.

True, but I'm not sure a longer less obvious message will help users
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to
More majordomo info at
Please read the FAQ at

 \ /
  Last update: 2005-03-22 13:22    [W:0.119 / U:0.492 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site