Messages in this thread | | | Date | Fri, 19 Jul 2002 23:26:14 +0200 | From | Fabio Massimo Di Nitto <> | Subject | Re: Linux Kernel 2.4.18 and 2.4.19 problems |
| |
Patrick Mansfield wrote:
>On Fri, Jul 19, 2002 at 09:26:07PM +0200, Thomas Langås wrote: > > >>qla2x00_set_info starts at address = f8836060 >>qla2x00: Found VID=1077 DID=2200 SSVID=1077 SSDID=2 >>scsi1: Found a QLA2200 @ bus 2, device 0x4, irq 16, iobase 0xdc00 >>scsi(1): Allocated 4096 SRB(s) >>PCI: Setting latency timer of device 02:04.0 to 64 >>scsi(1): Configure NVRAM parameters... >>scsi(1): 64 Bit PCI Addressing Enabled >>scsi(1): Verifying loaded RISC code... >>scsi(1): Verifying chip... >>scsi(1): Waiting for LIP to complete... >>scsi(1): Cable is unplugged... >>qla2x00: Found VID=1077 DID=2200 SSVID=1077 SSDID=2 >>scsi2: Found a QLA2200 @ bus 2, device 0x5, irq 17, iobase 0xd800 >>scsi(2): Allocated 4096 SRB(s) >>PCI: Setting latency timer of device 02:05.0 to 64 >>scsi(2): Configure NVRAM parameters... >>scsi(2): 64 Bit PCI Addressing Enabled >>scsi(2): Verifying loaded RISC code... >>scsi(2): Verifying chip... >>scsi(2): Waiting for LIP to complete... >>scsi(2): Cable is unplugged... >> I have an HSG80 connected on the other side and I got this problem with the beta6 drivers from qlogic.
The only way I made it working was using the kernel driver shipped with rh7.3 that has been modified to support the HSG80 (according to the changelog supported only by the beta6 series).
Fabio
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |