[lkml]   [2002]   [May]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH] 2.5.1[345]-dj Add cpqarray_init() back into genhd.c
On Mon, 13 May 2002 22:49:08 -0400, 
Adam Kropelin <> wrote:
>On Tue, May 14, 2002 at 12:24:23PM +1000, Keith Owens wrote:
>> The real problem appears to be cpqarray.c, it wraps the init/exit code
>> in #ifdef MODULE, so the init code is only available to modules. I
>> think that cpqarray.c should remove the #ifdef MODULE and use the same
>> init mechanism as other drivers, including module_init/exit. I don't
>> have a card and the code is a mess so I am not going to attempt a patch.
>I'm not seeing it. I see init_module() and cleanup_module() wrapped as you say
>but cpqarray_init() is outside the #ifdef. Also, two versions of cpqarray_setup
>are provided based on #ifdef MODULE but this doesn't look problematic to me.
>I'm a newbie, for sure. Am I overlooking something obvious?

The call to cpqarray_init() is from init_module() which does not exist
when the code is built in. See drivers/block/loop.c for an example of
the correct use of init and exit routines, using module_init and

To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to
More majordomo info at
Please read the FAQ at

 \ /
  Last update: 2005-03-22 13:26    [W:0.030 / U:1.776 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site