Messages in this thread | | | Date | Wed, 27 Feb 2002 10:48:25 -0700 | From | Andreas Dilger <> | Subject | Re: 3Ware Hard Bus Hang 2.4.18 > 220 MB/S |
| |
On Feb 27, 2002 10:25 -0700, Jeff V. Merkey wrote: > Running 4 3Ware 7810 Adapters with the updated 48 bit LBA firmware > for the 78110, and attached to 8 Maxtor 160 GB hard disks on each card > (32 drives total) striping Raid 0m across 5.6 terabytes of disk, I am > seeing about 216-224 MB/S total throughput on writes to local > arrays on 2.4.18.
Have you done any kind of variations on this configuration to see when or where the maximum throughput happens? Daniel and I were speculating about where the 3ware limits are. Specs say 100MB/s per adapter (for both 6000 and 7000 series), you would probably hit max bandwidth with 2 adapters. The drives themselves are not a limiting factor, unless you are down to striping across only 2 drives instead of all 8. I take it you are using the hardware RAID instead of software MD RAID?
> The system is also running an Intel Gigabit Ethernet Card at > 116-122 MB/S with full network traffic and writing this traffic to > the 3Ware arrays. All this hardware is running on a Serverworks > HE chipset with a SuperMicro motherboard and dual 933 Mhz PIII > processors.
Does this board have multiple PCI busses? Is the GigE card on a different bus than the 3ware cards?
Cheers, Andreas -- Andreas Dilger http://sourceforge.net/projects/ext2resize/ http://www-mddsp.enel.ucalgary.ca/People/adilger/
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |