lkml.org 
[lkml]   [2002]   [Feb]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: HPT366: DMA errors?
On 2002-02-21 23:14:11-0300, Cesar Suga wrote:
> Hello, all.
>
> I am using an ABIT BP6 board (SMP, 2 Celerons at 366MHz, none
> overclocked, *very* stable) which uses the HPT366 controller. I am getting
> through these messages when using the *original* ATA cable (never touched
> before) or a replacement one:
>
> hde: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hde: dma_intr: error=0x84 { DriveStatusError BadCRC }

I got this very same error on my normal VIA ide controller with every cable
I tried until I figured out that perhaps I should like, actually compile in
the VIA driver :)

Basically, reading would go without problems but writing would give the
above error and make the controller go back to PIO mode access. I agree
that it is most likely a cable problem but I wouldn't rule out the driver a
priori.

--
Wessel Dankers <wsl@fruit.eu.org>

Small animal kamikaze attack on power supplies
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:24    [W:0.050 / U:0.616 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site