lkml.org 
[lkml]   [2002]   [Feb]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectRe: Boot problem with PDC20269

    Hi Adam,

    http://www.tecchannel.de/hardware/817/index.html


    We do not put ATAPI devices on such HOSTS.
    The driver will not work w/ ATAPI there because it uses a different DMA
    engine location and is not supported in Linux.

    You will find greater success in putting your ATAPI device on the native
    south bridge.

    Cheers,

    Andre Hedrick
    Linux Disk Certification Project Linux ATA Development




    On Sat, 23 Feb 2002, Adam Huffman wrote:

    > When I try to boot a kernel with the latest IDE driver in order to
    > support my Promise UltraATA133 TX2 card, the system hangs at the point
    > where it should be listing the two drives attached to the card i.e. it
    > shows /dev/hdc which is a DVD drive, then stops. Sometimes I can reboot
    > with Alt-SysRq, sometimes a hard reset is needed. This happens with
    > 2.4.17+ide, 2.4.18-rc1, 2.5.5-dj1.
    >
    > Motherboard is MSI K7T-Turbo 2, K7 1.4, drives attached to the Promise
    > card are an IBM 60GXP and a Maxtor D740X-6L. The drives work when
    > attached to the VIA interface on the m/b.

    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.kernel.org
    More majordomo info at http://vger.kernel.org/majordomo-info.html
    Please read the FAQ at http://www.tux.org/lkml/

    \
     
     \ /
      Last update: 2005-03-22 13:24    [W:2.430 / U:0.272 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site