lkml.org 
[lkml]   [2002]   [Dec]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectAlteon AceNIC Coper Seen as Fibre ? (and incorrect settings)
    Sun UltraSparc 10
    kernel 2.4.20

    eth2: Alteon AceNIC Gigabit Ethernet at 0x1ff02900000, irq 6,7d0
    Tigon II (Rev. 6), Firmware: 12.4.11, MAC: 00:60:cf:20:92:fc
    PCI bus width: 32 bits, speed: 33MHz, latency: 64 clks
    eth2: Firmware up and running

    unplugging the utp cable, and plugging back in gives :

    eth2: 10/100BaseT link UP
    eth2: Optical link DOWN
    eth2: 10/100BaseT link UP

    but this card is not an Fibre (Optical) card ?

    also ethtool gives incorrect information :
    (ethtool 1.7)
    ---
    Settings for eth2:
    Supported ports: [ FIBRE ]
    Supported link modes: 10baseT/Half 10baseT/Full
    100baseT/Half 100baseT/Full
    1000baseT/Half 1000baseT/Full
    Supports auto-negotiation: Yes
    Advertised link modes: Not reported
    Advertised auto-negotiation: No
    Speed: 1000Mb/s
    Duplex: Half
    Port: FIBRE
    PHYAD: 0
    Transceiver: internal
    Auto-negotiation: off
    ---

    card is connected to 100mbit switch at full duplex
    and i think Auto-negotiation is on ?


    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.kernel.org
    More majordomo info at http://vger.kernel.org/majordomo-info.html
    Please read the FAQ at http://www.tux.org/lkml/

    \
     
     \ /
      Last update: 2005-03-22 13:31    [W:0.022 / U:122.348 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site