Messages in this thread | | | Date | Tue, 19 Nov 2002 11:23:38 +0100 | From | "Karsten 'soohrt' Desler" <> | Subject | Re: 2.4.20-rc1-ac4 HPT374 doesn't find connected ide drives |
| |
> I have the same board, and the controller works fine for me in 2.5.4*, as > 2.4-ac doesn't contain xfs suport. I only have one drive attached, but as I > remember I first had to configure the (raid) controller' BIOS (Ctrl-H at boot > time) (even for just a bunch of disks) before using the drives. But I'm not > 100%ly sure.
I've "been in" the controller BIOS a few times, but never configured anything because I'm using the linux md driver.
> I don't think there's any need for your patch, cause the hpt374 only has two > channels, but there are two controllers on that board.
This patch was just a desperate attempt since it wasn't working before. I reverted the patch right after I sent the mail to the lkml.
> ANother QUestion: Did you ever get the onboard via-rhine NIC working with > IO-APIC (both BIOS and kernel) enabled?
No I didn't. via-rhine.c:v1.10-LK1.1.14 May-3-2002 Written by Donald Becker http://www.scyld.com/network/via-rhine.html eth1: VIA VT6102 Rhine-II at 0xcc00, 00:04:61:43:88:d9, IRQ 16. eth1: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000. eth1: Setting full-duplex based on MII #1 link partner capability of 45e1. ... eth1: Transmit timed out, status 0003, PHY status 786d, resetting... eth1: reset did not complete in 10 ms. NETDEV WATCHDOG: eth1: transmit timed out - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |