Messages in this thread | | | Date | Thu, 03 Oct 2002 21:19:37 -0700 | From | Ben Greear <> | Subject | tg3 and Netgear GA302T x 2 locks machine |
| |
Got my two new Netgear GA302t nics today. They seem to use the tg3 driver....
I put them into the 64/66 slots on my Tyan dual amd motherboard.. Running kernel 2.4.20-pre8
eth2 is plugged into eth3 over cross-over cable.
The tg3 found and used them, mostly:
tg3.c:v1.1 (Aug 30, 2002) eth2: Tigon3 [partno(AC91002A1) rev 0105 PHY(5701)] (PCI:66MHz:32-bit) 10/100/1000BaseT Ethernet 00:40:f4:47:20:56 eth3: Tigon3 [partno(AC91002A1) rev 0105 PHY(5701)] (PCI:66MHz:32-bit) 10/100/1000BaseT Ethernet 00:40:f4:47:22:fd tg3: eth3: Link is up at 1000 Mbps, full duplex. tg3: eth3: Flow control is off for TX and off for RX. ... tg3: eth3: Link is up at 1000 Mbps, full duplex. tg3: eth3: Flow control is off for TX and off for RX. tg3: eth3: Link is down. tg3: eth3: Link is up at 1000 Mbps, full duplex. tg3: eth3: Flow control is on for TX and on for RX.
I tried to start traffic with pktgen, and the machine hangs solid. The last thing I see is:
[root@localhost root]# tg3: eth2: transmit timed out, resetting
Any ideas? Is this NIC supposed to work with tg3?
Thanks, Ben
-- Ben Greear <greearb@candelatech.com> <Ben_Greear AT excite.com> President of Candela Technologies Inc http://www.candelatech.com ScryMUD: http://scry.wanfear.com http://scry.wanfear.com/~greear
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |