Messages in this thread |  | | From | "Atul Mukker." <> | Subject | RE: megaraid driver only seeing 2 of 3 logical dirve. | Date | Thu, 27 Sep 2001 15:37:24 -0400 |
| |
The driver you are using seems to be not what we had released ( as I could make out from the dmesg ) . Which distribution/kernel are you using. I recommend you to get 1.17c, which is the latest driver. I will mail it separately to you since sending attachments on this list is probably not a good idea
Atul Mukker Software Engineer II
LSI Logic Corporation RAID Adapters Storage Division 6145-F Northbelt Parkway Norcross GA-30071 770-326-9187, 770-246-8765(Fax) E-mail: atulm@lsil.com HTTP: www.lsilogic.com
> -----Original Message----- > From: Byron Albert [SMTP:balbert@internet.com] > Sent: Thursday, September 27, 2001 1:57 PM > To: linux-kernel@vger.kernel.org > Subject: megaraid driver only seeing 2 of 3 logical dirve. > > I just added an ami megaraid card to a machine. I configured the 6 9gb > drives to look like 3 18gb drives and then booted. Linux only saw 2 of > the 3 drive. I think got the latest kernel and compiled and rebooted > and the same below is the relevant dmesg info. It says it detected 3 > logical drives but the driver only uses two of them. > > I really need this other drive so any help would be appreciated. > > Byron > > p.s. please cc me as I am in the proccess of joining the list > > > SCSI subsystem driver Revision: 1.00 > megaraid: v1.17a (Release Date: Fri Jul 13 18:44:01 EDT 2001) > megaraid: found 0x8086:0x1960:idx 0:bus 0:slot 5:func 1 > scsi0 : Found a MegaRAID controller at 0xf8808000, IRQ: 10 > megaraid: [C :B ] detected 3 logical drives > megaraid: channel[1] is raid. > megaraid: channel[2] is raid. > megaraid: channel[3] is raid. > megaraid: no BIOS enabled. > scsi0 : AMI MegaRAID C 254 commands 16 targs 3 chans 8 luns > scsi0: scanning channel 1 for devices. > scsi0: scanning channel 2 for devices. > scsi0: scanning channel 3 for devices. > scsi0: scanning virtual channel for logical drives. > Vendor: MegaRAID Model: LD0 RAID0 17354R Rev: C > Type: Direct-Access ANSI SCSI revision: 02 > Vendor: MegaRAID Model: LD1 RAID0 17354R Rev: C > Type: Direct-Access ANSI SCSI revision: 02 > Attached scsi disk sda at scsi0, channel 3, id 0, lun 0 > Attached scsi disk sdb at scsi0, channel 3, id 0, lun 1 > SCSI device sda: 35540992 512-byte hdwr sectors (18197 MB) > sda: sda1 > SCSI device sdb: 35540992 512-byte hdwr sectors (18197 MB) > sdb: sdb1 > > > - > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > Please read the FAQ at http://www.tux.org/lkml/ - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
|  |