Messages in this thread |  | | From | chris@boojiboy ... | Subject | 2.4.9-ac9 APM w/Compaq 16xx laptop... | Date | Wed, 12 Sep 2001 16:43:05 -0700 (PDT) |
| |
This was discussed awhile back, maybe there are answer.
Compaq Presario 1685. My bios supports ACPI
the roboot option "shutdown -r" does not work with this laptop when I compile either APM or ACPI. The behavior is a little different with each one.
When my bios is set ACPI=NO, and APM is compiled in: A 'shutdown -r' hangs after the "Restarting System" message. Depressing the power switch cause a power off.
When my bios is set ACPI=YES, and ACPI is compiled in: A 'shutdown -r' hangs after the "Restarting system" message. Depressing the power switch causes a reboot.
I have a feeling this is ReiserFS related.
dmesg shows:
Linux version 2.4.9-ac9 (root@oso) (gcc version 2.95.3 20010315 (release)) #1 Wed Sep 12 14:08:46 PDT 2001 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000ecc00 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000000bff0000 (usable) BIOS-e820: 000000000bff0000 - 000000000bfffc00 (ACPI data) BIOS-e820: 000000000bfffc00 - 000000000c000000 (ACPI NVS) BIOS-e820: 00000000fffc0000 - 0000000100000000 (reserved) On node 0 totalpages: 49136 zone(0): 4096 pages. zone(1): 45040 pages. zone(2): 0 pages. No local APIC present or hardware disabled Kernel command line: auto BOOT_IMAGE=linux ro root=302 Initializing CPU#0 Detected 381.177 MHz processor. Console: colour dummy device 80x25 Calibrating delay loop... 760.21 BogoMIPS Memory: 190560k/196544k available (1411k kernel code, 5596k reserved, 402k data, 220k init, 0k highmem) Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes) Inode-cache hash table entries: 16384 (order: 5, 131072 bytes) Mount-cache hash table entries: 4096 (order: 3, 32768 bytes) Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) CPU: Before vendor init, caps: 008021bf 808029bf 00000000, vendor = 2 CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line) CPU: After vendor init, caps: 008021bf 808029bf 00000000 00000002 CPU: After generic, caps: 008021bf 808029bf 00000000 00000002 CPU: Common caps: 008021bf 808029bf 00000000 00000002 CPU: AMD-K6(tm) 3D processor stepping 0c Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: AMD K6 PCI: PCI BIOS revision 2.10 entry at 0xfd8be, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware Unknown bridge resource 2: assuming transparent PCI: Using IRQ router ALI [10b9/1533] at 00:07.0 PCI: Found IRQ 10 for device 00:0a.0 PCI: Sharing IRQ 10 with 00:0f.0 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Compaq 12XL125 machine detected. Enabling interrupts during APM calls. Starting kswapd v1.8 ACPI: Core Subsystem version [20010615] ACPI: Subsystem enabled EC: found, GPE 6 ACPI: System firmware supports S0 S1 S4 S5 Processor[0]: C0 C1, throttling states: 8 AC Adapter: found Power Button: found Sleep Button: found Lid Switch: found vesafb: framebuffer at 0xfd000000, mapped to 0xcc808000, size 8128k vesafb: mode is 800x600x16, linelength=1600, pages=7 vesafb: protected mode interface info at c000:4d09 vesafb: scrolling: redraw vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0 Console: switching to colour frame buffer device 100x37 fb0: VESA VGA frame buffer device pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A block: queued sectors max/low 126325kB/42108kB, 384 slots per queue Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ALI15X3: IDE controller on PCI bus 00 dev 80 PCI: No IRQ known for interrupt pin A of device 00:10.0. Please try using pci=biosirq. ALI15X3: chipset revision 32 ALI15X3: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xfc90-0xfc97, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xfc98-0xfc9f, BIOS settings: hdc:pio, hdd:pio hda: FUJITSU MHF2043AT, ATA DISK drive ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx hdc: TOSHIBA DVD-ROM SD-C2202, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 8452080 sectors (4327 MB), CHS=8944/15/63, (U)DMA hdc: ATAPI 24X DVD-ROM drive, 128kB Cache Uniform CD-ROM driver Revision: 3.12 Partition check: hda: [PTBL] [559/240/63] hda1 hda2 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 PPP generic driver version 2.4.1 Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 149M agpgart: Detected Ali M1541 chipset agpgart: AGP aperture is 64M @ 0xe0000000 solo1: version v0.19 time 14:18:05 Sep 12 2001 PCI: Found IRQ 11 for device 00:09.0 solo1: joystick port at 0x10c1 solo1: ddma base address: 0x1060 Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] [pm] PCI: Found IRQ 10 for device 00:0a.0 PCI: Sharing IRQ 10 with 00:0f.0 Intel PCIC probe: not found. usb.c: registered new driver hub Yenta IRQ list 00b8, PCI irq10 Socket status: 30000010 PCI: Found IRQ 5 for device 00:14.0 usb-ohci.c: USB OHCI at membase 0xcd011000, IRQ 5 usb-ohci.c: usb-00:14.0, Acer Laboratories Inc. [ALi] M5237 USB usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected usb.c: registered new driver usblp printer.c: v0.8:USB Printer Device Class driver NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 1024 buckets, 8Kbytes TCP: Hash tables configured (established 16384 bind 16384) IPv4 over IPv4 tunneling driver GRE over IPv4 tunneling driver Linux IP multicast router 0.06 plus PIM-SM NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. FAT: bogus logical sector size 0 FAT: bogus logical sector size 0 reiserfs: checking transaction log (device 03:02) ... Using r5 hash to sort names ReiserFS version 3.6.25 VFS: Mounted root (reiserfs filesystem) readonly. Freeing unused kernel memory: 220k freed Adding Swap: 188960k swap-space (priority -1) PPP Deflate Compression module registered cs: IO port probe 0x0c00-0x0cff: clean. cs: IO port probe 0x0800-0x08ff: clean. cs: IO port probe 0x0100-0x04ff: excluding 0x378-0x37f 0x408-0x40f 0x480-0x48f 0x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: clean. cs: memory probe 0xa0000000-0xa0ffffff: clean. eth0: NE2000 (DL10019 rev 05): io 0x300, irq 3, hw_addr 00:E0:98:09:14:CA ttyS01 at port 0x02f8 (irq = 3) is a 16550A eth0: found link beat eth0: autonegotiation complete: 10baseT-HD selected - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
|  |